RETRO TURNTABLE/CD WITH RADIO AND BLUETOOTH CONNECTION TCD-682B INSTRUCTION MANUAL
WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions 2. Keep these instructions 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings.
15. been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 16. This appliance shall not be exposed to dripping or splashing water and that no object filled with liquids such as vases shall be placed on the apparatus. 17. Mains plug is used as disconnect device and it should remain readily operable during intended use.
2 Location of controls 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) 17) 18) 19) 20) 21) 22) 23) 24) 25) 26) 27) 28) 29) Dust cover Dial pointer Left speaker LCD display Bluetooth indicator FM stereo LED indicator CD door Volume knob Phono/Bluetooth button Program button Repeat button Right speaker Tuning knob CD door open button CD stop button Band selector Off/Function selector 3.
3 Hints for best reception:- AM : The receiver has a built-in am bar antenna. If AM reception is weak, slightly rotate or re-positioning of the unit will usually improve the am reception. - FM : The receiver has a built-in FM wire antenna (27) hanging at the rear cabinet. This wire should be totally unraveled and extended for best reception. Playing compact discs Getting started 1. Set the Off/Function selector (17) to CD position, open the CD compartment by pressing the CD door open button (14).
4 1. Set the Off/Function selector (17) to Phono/Aux/Bluetooth position and keep the Phono/Bluetooth button (9) in high level (Phono/Aux). 2. Set the speed selector to the proper position depending on the record to be played. 3. Place the record on the platter (use the spindle adaptor if required). 4. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to rotate. 5. Place the tone arm to the desired position on the record. 6. Adjust the volume to the desired level.