SuperCinema 3D Array ® Left, Center, Right 3-Channel Ultra-High-Performance Soundbars with Interaural Crosstalk Cancellation Owner’s Manual ®
Congratulations! Congratulations and thank you for purchasing GoldenEar Technology’s® SuperCinema® 3D Array® speaker! You are about to hear the spectacular difference this very special “front-stage” speaker will make in your multi-channel music and/or home theater system! You will be amazed to hear left and right channel information seeming to emanate from the far left and right of the room, as if you had separate left and right speakers! Our engineers’ many years of experience in developing loudspeakers ha
Preventing Speaker Damage USE AN APPROPRIATE AMPLIFIER. At high volumes a very powerful amplifier can overdrive your speakers and damage them. And if the amplifier is not powerful enough, it can produce distortion that can easily damage your speaker. (Consult your dealer for assistance.) DON’T BE FOOLED BY YOUR RECEIVER’S VOLUME CONTROL. It only adjusts how loud, it is not an indication of power output.
The Right Amount of Power A power-range rating is given in the specifications as a guide to indicate the approximate minimum and maximum power input of your GoldenEar SuperCinema 3D Array speakers. Amplifiers that meet or even exceed the speaker’s power-range rating are recommended as their greater power reserves provide better sound. But always use the speakers within their power-range rating to prevent damage — that is, keep listening levels below the point of obvious audible distortion.
Attaching Feet for Tabletop/Shelf Mounting If you going to set your SuperCinema 3D Array Speaker on a table or bookshelf, install the included Adjustable Center Stand Feet as follows: Tools required: #2 Phillips Screwdriver Small Flat Blade Screwdriver (for adjusting tilt back) Parts included: Two Adjustable Feet with Rubber-Tipped Set Screws Two Phillips head screws Instructions: 1.
Speaker Placement The GoldenEar Technology SuperCinema 3D Array speaker is designed to allow flexible placement while still providing a very large window of sound throughout your listening room. Please remember that although the following recommendations are usually valid, all rooms and listening sets-ups are somewhat unique, so do not be afraid to experiment with the speakers. Remember, whatever sounds best to you is correct.
Positioning SuperCinema 3D Array To ensure the best performance possible, observe the following placement guidelines: ACCURATE TIMBRE: For the most accurate and natural timbre, speakers’ high-frequency drivers should be at approximately ear level. Place the speaker above or below your TV, whichever position is closer to ear level.
Speaker Connection Turn your amplifier/receiver OFF before performing any connection steps, in order to prevent accidental damage to your amplifier. Your SuperCinema 3D Array speaker is equipped with a set of 5-way binding posts that can be used with bare wire, pin or spade connectors or banana plugs. Tighten the posts firmly by hand, but do not over tighten them. Make sure all wires are firmly fastened.
Setting Bass and Treble Controls on Receiver or Amplifier Normally we recommend that you set the “Bass” and “Treble” controls on flat (or off, or 0 dB). Same applies for a graphic equalizer; we recommend that you leave it flat (or off). This will give you the most accurate and natural sound. If you want more bass, raise your subwoofer’s “Level” control (or raise the subwoofer level on you’re a/v receiver), keeping in mind that even a little turn of the knob can make a big difference in the sound.
Setting Channel Levels and Bass Management in Multi-Channel Home Theater Systems VERY IMPORTANT: Home Theater System Bass Management Settings: On your Home Theater Receiver or A/V Processor’s Speaker Setup Menu, set Left, Center and Right Speakers To “SMALL” and set their Crossover Frequency to 120 Hz. See important additional setup details below. Multi-channel surround sound systems have bass management systems (systems which direct the bass to the various channels) which vary from unit to unit.
Wall Mounting Instructions If you are not comfortable performing the following mounting procedures we strongly suggest having a professional wall mount your speakers (see your Dealer). Please note that hardware for the wall is not included — make sure to use hardware appropriate for your wall type and the weight of the speaker being mounted.
Troubleshooting If you experience any difficulties with your SuperCinema 3D Array speakers, try the suggestions described below. If you are still having problems, please consult your GoldenEar Technology Authorized Dealer for assistance. 1. Make sure all your system interconnects and power cords are solidly in place. 2. Check that no foreign objects or liquid has entered the speaker. 3.
Specifications SuperCinema® 3D Array® XL Dimensions: 62-1/8" (157.8 cm) W x 4-3/4" (12.1 cm) H x 2-7/8" (7.2 cm) D Weight: 22 lbs. (10 kg) Frequency Response: 80 Hz – 35 kHz Efficiency: 91 dB Nominal Impedance: Compatible with 8 ohms Driver Complement: Eight 4-1/2" high-definition cast-basket MVPP™ mid/bass drivers Three HVFR™ High-Velocity Folded Ribbon tweeter Rec. Amplication: 20 – 300 Watt/channel SuperCinema® 3D Array® X Dimensions: 49-1/8" (124.7 cm) W x 4-3/4" (12.1 cm) H x 2-7/8" (7.
Limited Warranty 5-YEARS FOR DRIVERS AND CABINETS, 3-YEARS FOR ELECTRONIC COMPONENTS GoldenEar Technology warrants to the original retail purchaser only that this GoldenEar Technology Loudspeaker Product (the “Product”) will be free from defects in materials and workmanship for a period of five (5) years covering the drivers and cabinets, and three (3) years for the electronic components from the date of the original purchase from a GoldenEar Technology Authorized Dealer.