User Manual

WWW.GOLDENAGEPROJECT.COM
I
FEATURES
- High output dynamic cartrige for a big and
powerful sound.
- A clear, distinct and full bodied sound with a
presence peak for life-like vocals.
- Cardioid polar pa ern that reduces feedback
in live use.
- Three switches for tailoring the sound.
- Rugged metal body
USING THE D2
The D2 can be used with any standard mixer
or preamp. Use either a XLR to XLR or XLR to
1/4” plug low impedance cable. Do not use the
D2 with 48V phantom power engaged.
When mounting the D2 to the stand you may
need to remove the threaded adapter from the
mic holder, depending on the threading of the
mic stand.
The D2 should point towards the sound source.
Be aware of the proximity e ect (an increase
in bass response) when the mic is close to
the sound source). This can be a good or a
bad thing. You can adjust the bass response
by changing the distance from the mic to the
sound source for an optimum result in di erent
applications.
You can also use the bass rollo lters to lower
or remove the bass boost:
- The switch to the left enga-
ges a bass roll o lter that is
about 3 dB down at 120 Hz
and 5 dB at 50 Hz.
- The switch in the middle
engages a bass roll o lter
that is about 3 dB down at 210
Hz and 10 dB at 100 Hz.
The switch to the right enga-
ges a lter that lowers a range
centered around 5 kHz with a
maximum of about 4 dB. This
lter is active in about the
same frequency range as the
presence peak and therefore
lowers it when it is engaged.
Do experiment with mic pla-
cement and with the lters!
Large Diaphragm Dynamic Microphone
INTRODUCTION
Congratulations on choosing the Golden Age Project D2 microphone!
The D2 is a high quality dynamic microphone with a full bodied sound and an excellent transient
response. It has a consistent cardioid polar pa ern for a low o -axis coloration and a good rejection
of unwanted sounds.
The D2 has a marked presence peak centered around 5 kHz for a forward and distinctive sound.
Using the D2 close to the sound source results in a bass boost in the 75-300 Hz area due to the prox-
imity e ect which can help make voices and instruments sound fuller.
The three switches allows the user to adjust the frequency response. There are two switches for
selecting two di erent bass rollo lters and one switch for lowering the response in a frequency
range centered around 5 kHz.
Equipped with an internal windscreen, an external pop lter will usually not be needed. The 5/8’
thread adator in the stand adaptor matches di erent stand gauges.
The D2 is a versatile microphone that will perform very well in many applications, in the studio, on
stage and in broadcast applications, for speech/vocals and instruments like kick-drum and electric
bass.
D
D
2
2

Summary of content (2 pages)