User's Manual

ManualsBrandsGojo Industires ManualsElectronicsLow Power Transmitter in Soap Dispenser

PURELL® Point of Care Compliance Dispenser

Newly designed SmartLink™ enabled bottle holder with a push paddle registers a

hand hygiene event within the GOJO Activity Monitoring System. The blue LED light

provides visual confirmation that the hand hygiene event was recorded. The LED

light is designed to only illuminate when the user has depressed the push paddle far

enough to receive a full efficacious dose.

Robust Mount Solutions provide reliable installation wherever needed within the

patient zone to provide quick and easy access to PURELL Hand Sanitizer, improving

Hand Hygiene compliance. Main areas for placement include: Foot of Bed,

Horizontal and Vertical Pole/Mobile Equipment, Table/Equipment/Cart Edge, Vertical

Wall/Surface Mount and Tabletop.

This dispenser/holder accommodates the 12oz bottle of PURELL(R) Advanced Instant

Hand Sanitizer Gel.

Yes:

At the room level, if the Point of Care dispenser stays within the

room, all the events captured are associated to the in/out

opportunities of the room.

If the Point of Care dispenser moves from room to room, but

stays within the unit, all events captured are associated to the

in/out opportunities of the unit.

When the dispenser leaves the range of the AMS

network/gateway, the electronics within the Point of Care

dispenser will still continue to collect and store up to 200 events

locally. Then. when the dispenser returns to the gateway range,

the events will be pushed all at once to the gateway. Based on

this, we recommend developing a process to ensure the POC

dispensers do not leave the unit.

How does the POC

Compliance

Bracket work?

Is the Compliance

Rate calculated?

What if the POC

Compliance Bracket

leaves the unit?

Summary of content (16 pages)

PAGE 1
PURELL® Point of Care Compliance Dispenser How does the POC Compliance Bracket work? Newly designed SmartLink™ enabled bottle holder with a push paddle registers a hand hygiene event within the GOJO Activity Monitoring System. The blue LED light provides visual confirmation that the hand hygiene event was recorded. The LED light is designed to only illuminate when the user has depressed the push paddle far enough to receive a full efficacious dose.
PAGE 2
PURELL® Point of Care Compliance Dispenser User Instructions PURELL® Bottle Installation 1. Remove battery tab 2. Unlock the pump by rotating the nozzle counter clockwise as shown.
PAGE 3
PURELL® Point of Care Compliance Dispenser User Instructions PURELL® Bottle Installation – Un-Locked Position 3. Slide Locking Tab into un-lock position as shown 4. Squeeze the Collar and pull to open as shown ©2011. GOJO Industries. All rights reserved.
PAGE 4
PURELL® Point of Care Compliance Dispenser User Instructions 5. Insert bottle sliding bottom of bottle into tray first, then insert bottle into collar. 6. Push collar closed as shown. ©2011. GOJO Industries. All rights reserved.
PAGE 5
PURELL® Point of Care Compliance Dispenser User Instructions PURELL® Bottle Installation – Locked Position 1. With Collar open, slide Locking Tab into locked position as shown 2. Insert bottle sliding bottom of bottle into tray first, then insert bottle into Collar. ©2011. GOJO Industries. All rights reserved.
PAGE 6
PURELL® Point of Care Compliance Dispenser User Instructions 3. Push Collar closed as shown. 4. Insert pen tip into lock hole to release Collar, then squeeze and pull to open. ©2011. GOJO Industries. All rights reserved.
PAGE 7
PURELL® Point of Care Compliance Dispenser User Instructions SANITIZE INSTRUCTION 1..Depress Paddle until blue light appears. 2. Blue light indicates that a compliance event has occurred.
PAGE 8
PURELL® Point of Care Compliance Dispenser User Instructions Cover Plate Removal / Installation 1. Depress Cover Plate release in bottom of dispenser 2. Slide the Cover Plate down as shown. 3. To install the Cover Plate , slide the plate up until it clicks and locks into place.
PAGE 9
5830-10-868 PURELL® Point of Care Compliance Dispenser Installation Instructions Determine the location and orientation for mounting the dispenser Foot of Bed Mounting Location ©2011. GOJO Industries. All rights reserved.
PAGE 10
PURELL® Point of Care Compliance Dispenser 1. Measure the width of the Bed Footboard. For widths from ½” to 1-1/4” (12mm to 31mm) use part number 5835-500 ©2011. GOJO Industries. All rights reserved.
PAGE 11
PURELL® Point of Care Compliance Dispenser 2. Slide the appropriate Bracket down onto the Bed Footboard. 3. Slide the Dispenser with bottle onto the bracket. Pull up on the dispenser to ensure it’s locked. ©2011. GOJO Industries. All rights reserved.
PAGE 12
PURELL® Point of Care Compliance Dispenser Table /Cart Mounting Location 1. Use C-Clamp for table thicknesses up to 1-1/2”. 2. Mount to table as shown. Hand tighten ©2011. GOJO Industries. All rights reserved.
PAGE 13
PURELL® Point of Care Compliance Dispenser 3. Slide the Dispenser onto the clamp as shown until it clicks. Pull on the dispenser to ensure it's locked in place. ©2011. GOJO Industries. All rights reserved.
PAGE 15
PURELL® Point of Care Compliance Dispenser Cleaning /Disinfecting Instructions Recommended Disinfecting Solutions or Wipes 1 • K, Ethyl or isopropyl alcohol (70-90%) • L, Sodium hypochlorite (5.25-6.
PAGE 16
PURELL® Point of Care Compliance Dispenser FCC Statement • • • • THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE.