User Manual

! Warning (In according to FCC part 15.19):

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that

may cause undesired operation.

! Caution (Pertaining to FCC part 15.21):

Modiﬁcations to this equipment not expressly approved by GOJO Industries, Inc. could

void the user's authority to operate the equipment.

This unit is certified to FCC Part 15 Part C for intentional unlicensed radiators. FCC ID O76-T4SG0910A

LTX

Acvity Monitoring System

transmier module installaon procedure

PAGE 1
LTXTM Activity Monitoring System transmitter module installation procedure ! Warning (In according to FCC part 15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. ! Caution (Pertaining to FCC part 15.
PAGE 2
1. Press the LTX door latches inward to release the door. 3. Use a flathead screwdriver to lift the slot cover away from the cabinet. 5. Remove the LTX transmitter module from the packaging and straighten the antenna wire. 2. Pull the top of the door forward. 4. 6. Remove and discard the slot cover. Align the transmitter module base into the fitting in the door, and feed the antenna wire up through the retainierslots.
PAGE 3
7. With the antenna wire in place, swing the top of the module down and snap into place to secure the module. 8. Check to ensure that the battery tab is present. If the battery tab is not present, place a battery tab into the slot before proceeding to the next step. Battery tab 9. Insert the module cable into the jack on the front of the pump house, and press in firmly to secure the plug. 11. 10. Remove the battery tab to apply power to the LTX dispenser.