HDBaseT HDMI 2.
Thank you for purchasing from gofanco. Our products aim to meet all your connectivity needs wherever you go. For optimum performance and safety, please read the instructions carefully and keep this User’s Guide for future reference. If you need more information about our products, please visit www.gofanco.com. For technical support, please email us at support@gofanco.com. For drivers/manuals download, please go to www.gofanco.com/ download.
• • • Shut off power and make sure environment is safe before installation Do not plug the HDMI cables and IR cables in/out when the device is in use to avoid cable damage. Make sure they are plugged into the correct ports Use the included DC24V power adapter only. Make sure the specification matches if using 3rd-party DC power adapters Introduction The HDBaseT HDMI 2.
• • Supports Power over Cable (PoC) technology, powers both the transmitter unit and receiver unit using only one power adapter connected to either unit The Transmitter's HDMI loopout allows for a local display and monitoring of the extended display Package Contents • • • • HDBaseT HDMI 2.0 Extender with Loopout (1 Transmitter & 1 Receiver) 1x IR Blaster Extension cable and 1x IR Receiver Extension cable 1x Power adapter (24VDC/1A) User's guide Installation Requirements 1. 2. 3.
Product Layout Transmitter TX Front and Rear Panel No.
Receiver RX Front and Rear Panel 6 No.
Hardware Installation 1. 2. 3. 4. 5. 6. Power off all devices including your HDMI source and HDMI display(s). Connect your HDMI source device to the Transmitter's HDMI In connector with an HDMI cable (HDMI cable not included). Optional: Connect an HDMI display to the Transmitter's HDMI Out connector with an HDMI cable (HDMI cable not included) for local monitoring of the HDMI signal. Optional: Connect the IR Extension cable to the Transmitter's IR port.
7. 8. 9. 10. 8 Optional: Connect the IR Extension cable to the Receiver's IR port. This connection is needed only if you need to control your HDMI device from the remote location. See the application diagram on page 9 for proper cable connection. Plug the included power adapter into either the Transmitter's or Receiver's power jack, then plug power adapter into a reliable power source. One power adapter will power both the Transmitter and Receiver. Power on all connected devices.
Application Transmitter (TX) Receiver (RX) 9
Specifications 10
Disclaimer The product name and brand name may be registered trademarks of related manufacturers. TM and ® may be omitted on the user’s guide. The pictures on the user’s guide are just for reference, and there may be some slight differences with the actual products. We reserve the right to make changes without prior notice to a product or system described herein to improve reliability, function, or design.
Thank you for choosing gofanco www.gofanco.