e 1a 8 1b 1c 1d 1 7 9 3 2d 2b 2c 2a 2 4 GN9120_cover_1_flap.
English - GN 9120 user guide About the GN 9120 This user guide provides you with information and instructions on assembling, using and maintaining your GN 9120. This guide contains the following sections: The GN 9120 is a cordless headset solution, made up of a cordless headset and a base unit that is connected to your telephone. The GN 9120 gives you full mobility, handsfree convenience and superior sound quality for your telephone conversations.
Battery charging and use When not in use, place the headset in the base unit, ensuring the link-up indicator (1b) is not lit, to charge the battery. If the link-up indicator is lit after placing the headset, remove the headset from the base unit and place it in the base again. If battery charge is too low, a beep will be heard in the headset every 20 seconds. Note: The battery charging indicator (1d) on the base unit will flash continuously during charging and be lit when the battery is fully charged.
Received sound volume adjustment Adjust the volume of received sound according to personal preference. To adjust the volume: 1. Make a telephone call and ask the person you are calling to assist you. 2. Adjust the volume of the received sound by pressing the + or – button. This setting is now stored in the headset. Note: When the volume reaches maximum or minimum, you will hear a beep in your headset. The product will save the set volume in its memory.
Earhook (4) wearing style. With an earhook, you can wear your headset on your right or left ear, according to personal preference. Complete the following steps: 1. Rotate the boomarm 180 degrees. Note: The boomarm cannot be rotated a full 360 degrees. Do not force the boomarm when it cannot be rotated any further. 2. Detach the earhook from the earhook clutch. 3. Rotate the inner earhook ring 180 degrees. 4. Insert the earhook into the earhook clutch.
To answer a telephone call using the GN 1000 RHL: 1. Remove the headset from the base unit when you receive a call. The link will be established and the on-line indicator (1a) on the front of the base unit will begin to flash. Note: If you are already wearing the headset, simply press the multifunction button (2d) on the headset for more than 2 seconds to answer the incoming call. To end the call, press the multifunction button momentarily or place the headset in the base unit.
Memory reset When the battery is removed or the power adapter is unplugged (for at least a few seconds), all customised headset settings (clear dial tone, transmit volume, received sound volume and tone control) are returned to factory-set default settings. Registering a new master headset A new master headset may be registered to the product in case of loss or damage to the original headset. To register a new master headset, complete the following: 1. Unplug the power adapter for a couple of seconds. 2.