Bedienungsanleitung GN 9120 DG User Guide GN 9120 DG
1. Inhalt der Verpackung: 1. 2. 2a. 2b. 2c. 2d. 3. 4. 5. 6. 7. 1 – Inhalt Ladestation (Basis) Headset Online-Anzeige Lautstärkeregler – Lautstärkeregler + Multifunktionstaste Standfuß (Basis) Ohrhaken Ohrkissen Ohrplatte Netzteil Bedienungsanleitung GN 9120 DG b d c Diese Bedienungsanleitung gibt Ihnen Informationen und Hinweise zur Installation und Benutzung Ihres GN 9120 DG.
2. Akku des Headsets laden min full Erstes Laden des Akkus Der Akku im Headset ist bei Lieferung nicht geladen und muss vor der Benutzung mindestens 20 Minuten geladen werden. Das vollständige Laden des Akkus dauert 1,5 Stunden und bietet dann eine Gesprächszeit von 12 Stunden. Die Akku-Ladeanzeige an der Basisstation blinkt beim Laden und leuchtet permanent, wenn der Akku vollständig geladen ist. Hinweis: Das Headset kann sich beim Laden des Akkus erwärmen.
3. Anmeldung an der Basisstation des DECT-Telefons Vor der Benutzung Ihres GN 9120 DG müssen Sie das Headset an der Basisstation Ihres DECT-Telefons anmelden. 6 sec Bitte lesen Sie vor der Anmeldung zunächst die Anweisung zur Anmeldung eines neuen DECT-Headsets bzw. GAP-fähigen Mobilteils, die Sie in der Bedienungsanleitung Ihres DECT-Telefons finden. 1. Geben Sie für Ihr DECT-Telefon den System-Authentifizierungscode 0000 ein, so dass dieser mit dem voreingestellten PIN-Code des GN 9120 DG übereinstimmt.
4. Funktionen und Einstellungen Hörerlautstärke/Empfangslautstärke einstellen Bitten Sie jemanden Sie anzurufen. Sie können mit der PLUS Taste (2c) die Lautstärke erhöhen und mit der MINUS Taste (2b) die Lautstärke verringern. Annehmen und Beenden von Anrufen Ein eingehender Anruf wird Ihnen durch einen Signal-Ton im Headset angezeigt. Diesen können Sie durch einmaliges Drücken der Multifunktionstaste (2d) entgegennehmen.
5. Wechseln des Tragestils Trageseite des Mikrofonarms wechseln (L bzw. R) Siehe Abbildungen: 180º 180º Tragestil von Überkopfbügel zu Ohrring wechseln 5.1 Ggf. das Ohrpolster abnehmen. 5.2 Überkopfbügel wie gezeigt halten und mit dem Daumen auf die Headsethörkapsel drücken. 5.3 Das "L” bzw. "R” in der Ohrplatte zur quadratischen Öffnung im Headset ausrichten. Den Ohrring auf die Headsethörkapsel drücken. Trageseite wechseln (L bzw. R). Die Tasten am Headset müssen nach oben weisen.
6. Problemlösungen Bei Problemen oder Fragen zur Funktionalität besuchen Sie bitte unsere Webseite www.gnnetcom.de – Technischer Support. Dort finden Sie FAQ’s und weitere ausführliche Informationen zum Produkt. Direkten Kontakt zu unserem Kundenservice finden Sie unter der Telefonnummer: 08031/26 51 - 0 oder per Email: Techsupport@gnnetcom.de 7. Informationen zum Betrieb und Sicherheit Akku austauschen Der mit dem Gerät gelieferte Akku wird über Jahre hinweg funktionieren.
Reinigung und Wartung Reinigen Sie das Headset, den Headsetbügel und Ohrring bei Bedarf mit einem leicht angefeuchteten Tuch. Verwenden Sie nur Wasser und ggf. etwas Spülmittel. Achten Sie darauf, dass keine Feuchtigkeit in die Buchsen oder andere Öffnungen gerät. Die Basisstation und Kabel können bei Bedarf trocken entstaubt werden. Ohrpolster und Ohrplatte können gereinigt bzw. ausgetauscht werden. Benutzen Sie für die Reinigung nur Wasser und ggf. etwas Spülmittel. • Für Reinigung bzw.
User Guide GN 9120 DG Deutschland: GN Netcom GmbH Traberhofstraße 12· 83026 Rosenheim Tel.: 0 80 31 - 2 65 10 · Fax: 0 80 31 - 6 98 95 Email: info.de@gnnetcom.com · www.gnnetcom.
1. Contents of the pack: 1. 2. 2a. 2b. 2c. 2d. 3. 4. 5. 6. 7. Charging station (base) Headset Online display Volume control – Volume control + Multifunction button Stand (base) Earhook Ear cushion Earplate AC adapter 1 – Content User Guide GN 9120 DG b d c This user guide contains information and notes on installing and using your GN 9120 DG.
2. Charging the headset battery min full Charging the battery for the first time The battery in the headset is not supplied charged and must be charged for at least 20 minutes before use. Full charging of the battery takes 1.5 hours and will then provide 12 hours of talk time. The battery charge display on the base station flashes during charging and is on permanently when the battery is fully charged. Note: The headset may become warm whilst the battery is being charged.
3. Checking in on the DECT telephone base station Before using your GN 9120 DG, you will need to check the headset into the base station of your DECT telephone. 6 sec Before checking in the headset, please first read the instructions on how to check in a new DECT headset or GAP-compatible handset. These can be found in the user guide accompanying your DECT telephone.
4. Functions and settings Setting the headset/receiver volume Ask someone to call you. You can use the PLUS button (2c) to increase the volume and the MINUS button (2b) to lower the volume. Taking and ending calls Incoming calls are indicated to you by a signal you hear in the headset. Calls can be taken by pressing the multifunction button (2d) once. To end a telephone call, press the multifunction button (2d) on the headset once more.
5. Changing the wearing style Changing the side on which the boom is worn (L or R). See diagrams: 180º 180º Changing the wearing style from the headband to the earhook 5.1 Remove the ear cushion if necessary. 5.2 Hold the headband as illustrated and press the headset receiver’s speaker with your thumb. 5.3 Line up the “L” or “R” in the earplate with the square hole in the headset. Press the earhook onto the headset receiver. Change the side on which it's worn (L or R).
6. Troubleshooting In the event of any problems or queries on functionality, please go to our Web site at www.gnnetcom.com or contact your headset dealer. 7. Information on operation and safety Replacing the battery The battery supplied with your GN Netcom headset will function for many years. When it needs to be replaced, please proceed as follows: 1. Remove the earhook/headband. 2.
Cleaning and maintenance Clean the headset, the headset hook and earhook as necessary using a slightly damp cloth. Use only water and a little washing-up liquid if necessary. Ensure that no moisture penetrates the jacks or any other openings. The base station and cable can be dusted with a dry cloth as required. The ear cushion and earplate can be cleaned or replaced. To clean them, use only water and a little washing-up liquid if necessary.
GN Netcom Worldwide Headquarters · Metalbuen 66 DK-2750 Ballerup Denmark www.gnnetcom.