Jabra BIZ 2400 USB User manual www.jabra.
© 2008 GN Netcom A/S. All Rights Reserved. Thank you This user guide is published by GN Netcom A/S. Thank you for purchasing the Jabra BIZTM 2400 USB headset. We hope you enjoy it! This instruction manual will get you started and ready to make the most of your headset. The information in this user guide is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by GN Netcom A/S.
How to connect headset to PC Plug the headset into a free USB port on your PC. Once connected, the headset's active mute and hookswitch buttons will be illuminated. The first time connected, your PC displays a small pop-up message in the task bar to indicate that a new device has been found. You are now ready to use the headset. How to adjust volume on the Headset Use the wheel at the center of the USB controller to adjust the volume. Turn clockwise to turn up and counterclockwise to turn down.
How to activate optional features How to use the Soft Buttons. The USB controller includes two soft buttons, labeled × and O, respectively. You are able to program the headset to use these two buttons for any of several functions. For example, you can configure one of the soft buttons to control the Bluetooth connection to a mobile phone See the section about using Jabra PC Suite, below, for details.
The Settings Tab The options on the Settings tab enable you to control the Audio protection (Intellitone). WARNING: Do not remove the headset from your PC while the firmware is being updated and make sure your computer will not shut down or go into sleep or standby mode during the process. (Should a disconnection unintentionally occur, please retry from step 1) To apply a firmware update: 1. If you have not already done so, then attach your headset to your computer. 2.
Need more help? Once you have selected the mobile as one of the functions for your softbuttons, a Mobile tab will appear in the Jabra Control Center. You will be able to clear your paring list, thereby deleting the mobile phones paired to the headset. Once you have clicked Clear pairing list – the headset will automatically enter a pairing mode.
Certification and safety approvals CE This product is CE marked according to the provisions of the R & TTE Directive (99/5/EC). Hereby, GN, declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. For further information please consult http://www.jabra.