Vega X series Smart Intercom User manual
Copyright information Copyright © 2018 Glory Star Group Limited. All rights reserved. All intellectual property rights in this publication are owned by Glory Star Group Limited and protected by applicable copyright laws and international treaty provisions. Glory Star Group Limited retains all rights not expressly granted. No part of this publication may be reproduced in any form whatsoever or used to make any derivative work without prior written approval by Glory Star Group Limited.
Safety and warning information Read this user manual All safety and operating instructions in this user manual should be read before operating the product Keep this user manual This user manual should be retained for future references. Head Warnings Be cautious about warning signals on the product. Follow Instructions Please follow instructions in this user manual Attachments To avoid danger, please do not use attachments not recommended by the product manufacturer.
Avoid over heat Do not place heavy objects on top of the unit and at sealed areas to avoid heat ventilation problems. Product Protection Please do not place any attachment or parts inside the product to avoid contacts with voltage points that could result an electric shock or fire. Heat Ventilation There is no heat ventilation on the upper and lower part of the product, therefore to avoid overheating, please do not block any ventilation openings with objects (e.g. carpet).
Overloading Do not overload wall outlets, extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock. Damage Handling Unplug this product from the outlet of wall and request qualified service personnel under the following conditions: • when the power supply cord or plug is damaged • when the picture display gets dimmer • when liquid has been spilled or objects have fallen on to the product • when the product has been exposed to rain or water.
Storage Keep the product at dim areas, room temperature and low humidity to maintain original condition. This will avoid danger. Transportation Since the product consists of glass and delicate electronic components, excessive shock or drop will result damages. Please handle the product carefully to minimize shock during transportation. Recycling The product utilizes tin-lead solder, and has a fluorescent lamp containing a small amount of mercury.
Product over view VegaX offers different interfaces as well on the rear as on the front side. All interfaces are integrated and functional on Android level and can be accessed from custom applications through corresponding libraries.
Three types of mounting
Rear Input/Output A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 +12V GND I/O(INPUT) I/O(INPUT) +5V WIEGAND_D0 WIEGAND_D1 GND RS485_A RS485_B B1 B2 B3 B4 B5 B6 C1 C2 D E OUT1 COM1 NC OUT2 COM2 NC +12V GND Ethernet with POE MICRO_USB
Installation & Quick start
Gang box(Optional) installation Cut an area of Vega X location on the wall Use screw or glue to hold on the Gang box
VOD073 Portrait: 128(W) *227(L) MM Connect POE Install VegaX Place the Vega into the Gang box(optional) and the front cover into the Vega. Connect to Wi-Fi Go to the Android setting and select Wi-Fi Select the network or source you wish to connect to from the list. Once the Gang box (Optional) installation of the wall has been completed, the RS232/ RS485 / GPIO/ KNX wire and power cable is connected, the device will power on.
license and regulation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.