GLOBEL SENSOR MANUAL Model：BROADBAND 04/03/2019, 15.
! 1. Electrical Ratings and Requirements Product Supply Ratings Battery: version 1 3V Primary Cell, version 2 3.7V Lithium Polymer cell, version 3 3.0v MnO2 printed battery WARNING These procedures should only be performed by trained installation technicians. Installer must conform to local standards and ordinances as required. 04/03/2019, 15.
1.
How to operate the Globetracker tags For Globetracker sensors (complete samples, 1min interval): Press the button When the tags are powered on there is a buzz for 3s and LED will blink for 10s.
2. Setting up the GW 1 2 3 4 Connect the antenna to the Gateway Place the sniffer in the area to be monitored Power on the sniffer Connect the sniffer to your WIFI. See instructions 5 Locate and check the sniffer log files.
Step 4 Config the WIFI network on the Gateway: 1) Power on the Gateway and wait for one minute, you will see a WIFI hotspot “NeosmartAP” on your computer. Connect to this hotspot with password: neosmart **The WIFI hotspot has a timeout for about 2 minutes once it shows up. After the timeout LoRa stack will come up. The WIFI config will be dismissed and the hotspot will disappear.
2) Open the browser, go to 192.168.1.10 for WIFI setup.
1) Once NeosmartAP disappears the sniffer connects to the wifi assigned. Go to the local router and check the ip address of the sniffer. The name of the sniffer is “Neosen_SnifferSZ” 2) Use any terminal emulator that supports SSH to log into the sniffer. The example below uses WinSCP.
3) Go to /home/pi/lora_gateway/util_pkt_logger, then check the most recent csv file You can check via the last changed time of the file or the time (UTC) on the file name. (…20200908T203742Z.csv) Find the LoRa packet from the Gateway log Due to the noise, there may be a lot of lines of data in the log csv file. Below are some tips of how to keep track of the data.
2.
Battery Option 3 Shelf life Cycle life 1 Month Storage 25C Cycle life 3 Month Storage 25C Cycle life 6 Month Storage 25C Cycle life 1 Month Storage 10C Cycle life 3 Month Storage 10C 6 months 15000 transmissions 14000 transmissions 13000 transmissions 15000 transmissions 14500 transmissions 90 day cycle use case 1. Log 15 minutes, Transmit 1 hour interval a.
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference.
