HUDGPS User Manual Rev.A00 HUD GPS Speed Meter with Bluetooth By MTK Chipset HG-100 1 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.com Tel:+886-6-6007799 Fax:+886-6-5053381 http://www.gtop-tech.com © Copyright 2006 GlobalTop Inc.
HUDGPS User Manual Rev.A00 Precaution GPS is possessed and maintained by USA DOD (Department Of Defense), which has the absolute right to degrade the GPS signal without alert in advance. GPS Signal reception will be certainly effected if you are inside building, tunnel and extreme urban environment. In these cases, it doesn’t mean that the device is defective Drive safety always has to be the first priority while using this device. For safety, don’t operate this device while driving.
HUDGPS User Manual Rev.A00 Chapter 1 Product Introduction 1.1 Description GlobalTop Technology Inc. is proud to present you the most innovative GPS application product, HUD GPS Speed Meter with Bluetooth, HG-100. HG-100 is combined with the three exciting modern technology, Heads-Up Display (HUD), GPS, and Bluetooth.
HUDGPS User Manual Rev.A00 1.2 Electrical Characteristics Protocol NMEA 0183 v3.01 (DefaultΚGGA,GSA,GSV,RMC,VTG) MTK NMEA Command Baud Rate 38400,N,8,1 (Default) Update Rate 5 Hz Datum WGS84 Channel 32-channel satellites all-in-view tracking Frequency L1, 1575.42MHz Hot Start 1 sec. (Average) Warm Start 34 sec. (Average) Cold Start 36 sec.
HUDGPS User Manual Rev.A00 1.3 System Operating Chart HUD display Bluetooth Connection for GPS Navigation 5 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.com Tel:+886-6-6007799 Fax:+886-6-5053381 http://www.gtop-tech.com © Copyright 2006 GlobalTop Inc.
HUDGPS User Manual Rev.A00 1.4 Product Appearance 4 1 2 3 1 Direction Indicator 2 Light Sensor 3 Speed Indicator Indicate the speed of the moving vehicles for 1~999 4 Speed Unit Indicate the speed unit, kilometer/hour and mile/hour Indicate the direction of the moving vehicles Automatic change the brightness of the LEDs 5 7 6 6 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.
HUDGPS User Manual Rev.A00 5 Function Touch 6 Power inlet Car charger power input 7 Power Button Power ON/OFF, HUD Off (power saving mode) Function switch for speed unit and speed warning system 8 LED 8 Indicator Red LEDΚGPS is fixed or not fixed / Power On Green LEDΚBattery Indicator Blue LEDΚBluetooth is connected or not connected 9 Permanent The location of permanent magnet Magnet 9 7 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C.
HUDGPS User Manual Rev.A00 1.4 Quick Hardware Installation A. Paste the heat insulation film 1. Please find the most suitable position of the heat insulation film on the windshield window to get the best projecting angle. It is recommended to put the heat insulation film on the left under corner of the windshield window. 2. Remove the backside film of the heat insulation film and apply to the choosing position on last step. Gently smoothing this film onto windshield to avoid bubbling generated.
HUDGPS User Manual Rev.A00 1. 2. 3. 4. Starting your car and plug in the car charger to the HG-100. Press the power button of the HG-100 last 2 seconds. Put the HG-100 on the iron plate and it will be magnetic fixed on the plate. HG-100 will show “GPS” until get position fixed. 5. In the open sky, the HG-100 will get fixed under 1 minute. 6. After GPS position fixed, the HG-100 will project the heading and speed of drive information. 9 GlobalTop Technology Inc.
HUDGPS User Manual Rev.A00 Chapter 2 Basic Operation Instruction 2.1 Note before Use The HUD function of HG-100 is only activated with the car charger plug-in. But without car charger plug-in, the GPS and Bluetooth function still remain. Keep HG-100 embedded battery charged firstly at least 1 hrs. Just press Power button ON, HG-100 will start GPS signal searching automatically without any other setting.
HUDGPS User Manual Rev.A00 2.3 Speed Unit switch between km/h, mile/h Press Function Touch button to switch km/h and mile/h. Function Touch button Speed Unit indicate 1 sec button pressed HUD will show the setting of speed unit. Speed Unit Switch 0.5 sec button pressed HUD will change km/h and mile/h every time. Speed Unit Set 1 sec button pressed HG-100 will keep the speed unit. 11 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C.
HUDGPS User Manual Rev.A00 2.4 Speed Warning Function Press Function Touch button to set the speed warning. Function Touch button Speed Warning indicate 2 sec button pressed HUD will show the setting of speed warning. Speed Warning Switch 1 sec button pressed HUD will change the setting of speed warning as a loop.
HUDGPS User Manual Rev.A00 2.
HUDGPS User Manual Rev.A00 2.6 HG-100 Button Function Power ON/OFF and Screen ON/OFF Power Button Press 2 seconds Power ON and OFF Press 1 second When power on, HG-100 will switch on and off the screen Speed Unit Mode Press 1 second Press0.5 second HG-100 will into the speed unit mode. When in the speed unit mode, HG-100 will change the speed unit indicator. Speed Warning Setting Mode Function Touch Press 2 seconds Press 1second HG-100 will into the speed warning setting mode.
HUDGPS User Manual Rev.A00 Chapter 3 Bluetooth Connection 3.1 Configuration setup with PC connection Here is a sample to show you how to connect the HG-100 with your PC, software install and basic function test. 1) First, select a PC with Bluetooth interface. Or you can purchase Bluetooth adapter for your PC. Please contact with your PC’s sales about this.
HUDGPS User Manual Rev.A00 4) If there is already one, please check the content. Some Bluetooth device will enable the secure connection. Please refer to the configuration as above to uncheck it. 5) Power on HG-100. If the battery is ready, you should see 2 LED light upǺthe blue LED blink 3 times/sec means Bluetooth is activated and waiting for connection. Another static red LED shows the GPS module is started and is inquiring position information.
HUDGPS User Manual Rev.A00 9) You should find the service SPP slave, right click and select [Connect to Bluetooth Serial Port]: 10) The follow message will show: 11) And the connection successful message: 12) Back to the Bluetooth service view, you should see the icon changed to 17 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.com Tel:+886-6-6007799 Fax:+886-6-5053381 http://www.gtop-tech.com © Copyright 2006 GlobalTop Inc.
HUDGPS User Manual Rev.A00 [Connected]: 13) If you wish to use the connection more easily next time, you can create a shortcut for thisǺ 14) You will see the shortcut you just created: 18 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.com Tel:+886-6-6007799 Fax:+886-6-5053381 http://www.gtop-tech.com © Copyright 2006 GlobalTop Inc.
HUDGPS User Manual Rev.A00 3.2 Configuration setup with PDA connection Following will show how to configure the Bluetooth connection on PDA. It may be different from other PDA models. 1) Power on your PDA and the Bluetooth host. 2) Power on HG-100. If the battery is ready, you should see 2 LEDs indicationǺthe blue for Bluetooth blinks 3 times/sec. It means the Bluetooth module is activated and waiting for connection. The red LED for GPS, means the GPS module is activated and is inquiring GPS signal.
HUDGPS User Manual Rev.A00 5) Then the Bluetooth connection wizard show up, select [Explore a Bluetooth device] and click [Next]. In the next page, click the box to search Bluetooth devices. Your PDA will find the Bluetooth GPS and show it in the window. Click the icon to search for service. 6) Back to the [Explore a Bluetooth device] as below. Click [Next] to list service on Bluetooth GPS. [SPP slave] should appear in the service list box, click it and click [Next] to finish shortcut creation.
HUDGPS User Manual Rev.A00 7) Back to the main screen of [Bluetooth manager] as below. Please double-click the icon to connect the Bluetooth GPS Receiver . If connection successful, a green arrow will show as below at right. 8) You may start to use any map/navigation software and use the GPS function now. 21 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.com Tel:+886-6-6007799 Fax:+886-6-5053381 http://www.gtop-tech.
HUDGPS User Manual Rev.A00 Appendix A. Warranty HG-100 with one-year warranty is except these cases, like abnormal use, natural disaster, accidence damage and un-authorized repairing, etc. ¾ High temperature environment should be avoided. One year warranty is not included under the following conditionsǺ ¾ ¾ Damages caused by natural disaster, accidents etc.
HUDGPS User Manual Rev.A00 Appendix B.
HUDGPS User Manual Rev.A00 ¾ Inside the tunnel, GPS signal is blocked. ¾ Covers above, GPS signal is blocked. ¾ Inside buildings, GPS signal is blocked. ¾ Beside some buildings, GPS signal is disturbed. ¾ Inside forests, or too many covers, GPS signal is disturbed. If you use HG-100 inside the car, some anti-sunlight windscreen film will make the GPS signal degraded or signal blank. GPS satellite is owned by America military; sometimes they will tune-down the accuracy by some reason.
HUDGPS User Manual Rev.A00 25 GlobalTop Technology Inc. th 16 Nan-ke 9 Rd Science-based Industrial Park, Tainan 741, Taiwan, R.O.C. email:sales@gtop-tech.com Tel:+886-6-6007799 Fax:+886-6-5053381 http://www.gtop-tech.com © Copyright 2006 GlobalTop Inc.
FCC Caution 1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3.