GlobalSat LT-200 Series User Manual Version: 1.1 USGlobalSat Incorporated GlobalSat WorldCom Corporation 14740 Yorba Court Chino, CA 91710 st 16F., No. 186, Jian 1 Rd, Zhonghe Dist., Tel: 888.323.8720 / Fax: 909.597.8532 sales@usglobalsat.com www.usglobalsat.com New Taipei City 23553, Taiwan Tel: 886.2.8226.3799/ Fax: 886.2.8226.3899 service@globalsat.com.tw www.globalsat.com.
TABLE OF CONTENTS 1. Warning ................................................................................................................................................. 3 2. Welcome ................................................................................................................................................ 4 3. Introduction and Features ................................................................................................................... 5 3.1 Introduction ............
1. Warning USE RESPONSIBLY. READ ALL INSTRUCTIONS AND SAFETY INFORMATION BEFORE USE. Globalsat Worldcom Corporation / USGlobalsat, Inc., will not accept any responsibility whatsoever for accidents or violations of local Laws resulting from failure to observe common sense precautions and local laws. Your personal judgment, traffic regulations, and common sense must always take precedence over any directions produced by GPS receiver or the mapping software.
2. Welcome Thank you for purchasing the GlobalSat LT-200. The LT-200 is a sleek, compact and feature rich asset monitoring tracking device. The LT-200 unit incorporates a wide array of custom feature, functions and configurations for unique client requirements.
3. Introduction and Features 3.1 Introduction LT-200 is a LoRa tracking device with fast GPS acquisition time. It is compact, portable and stylish in design capable to connect LoRa wireless networks. Users can easily and remotely configure LT-200 and display GPS locations on remote monitoring / tracking platforms. LT-200 is set to work with Moving Object Security & Tracking Solution. (M.O.S.T.
3. Introduction and Features (Continued) 3.2 LED Indicators Power Status LED LED Orange Constantly Lit Orange Blinking Red Constantly Lit Red Blinking Quickly State LT-200 is fully charged. LT-200 is being charged. Battery power is low USB configuration mode LoRa LED LED Blinking Quickly State Data transmitting.
4. Device Operation 4.1 Device charging Using the device for the first time, rechargeable battery will require a complete 100% charge before LT-200 is operable. To maximize your device’s battery life, proceed by performing the steps listed below. 1. Connect the charging clip to LT-200's battery charging contacts and connect the USB side to AC adaptor. 2. Allow at least 4 hours of battery charging time.
4.2 Power 1. To turn the device “ON”, press and hold the power button for 3 second. 2. To turn the device “OFF”, press and hold the power button for 3 seconds until the device vibrates. 3. To perform a hard reset, press and hold the power button for 8 to 10 seconds.
4.3 Geo-fence button Activate geo-fence function: While pressing and holding the geo-fence button for 2 seconds, LT-200 would beep and start to get GPS fix. It would keep beeping till device gets GPS fix. After getting GPS fix, it would beep for 1.5 seconds, vibrate, and make itself as the center of the circular geo-fence area whose radius is 200 meters (default value). If device moves out the geo-fence area, device would trigger the alarm action of beeping 3 times and then turn silent for 1.
5. Contact Information GlobalSat WorldCom Corporation Address: 16F., No.186, Jian 1st Rd., Jhonghe Dist., New Taipei City , Taiwan TEL: +886-2-82263799 FAX: +886-2-82263899 6. Safety Information • Please consult your airline prior to the operation of this product in the aircraft. . Operating this product in environments emitting intensive radio waves or radiation can affect the operation and functionality of this product. • Avoid use in humid or rainy environment.
7. Limited Warranty Globalsat/USGlobalsat (1) Year Limited Warranty FOR CONSUMERS, WHO ARE COVERED BY CONSUMER PROTECTION LAWS OR REGULATIONS IN THEIR COUNTRY OF PURCHASE OR, IF DIFFERENT, IN THEIR COUNTRY OF RESIDENCE, THE BENEFITS CONFERRED BY THIS WARRANTY ARE IN ADDITION TO ALL RIGHTS AND REMEDIES CONVEYED BY SUCH CONSUMER PROTECTION LAWS AND REGULATIONS. THIS WARRANTY DOES NOT EXCLUDE, LIMIT OR SUSPEND ANY RITGHTS OF CONSUMERS ARISING OUT OF NONCONFORMITY WITH A SALES CONTRACT.
fulfillment of its warranty obligation. A replacement product or part, including a user-installable part that has been installed in accordance with instructions provided by Globalsat/ USGlobalsat, assumes the remaining warranty of the original product or ninety (90) days from the date of replacement or repair, whichever provides longer coverage for you. When a product or part is exchanged, any replacement item becomes your property and the replaced items becomes Globalsat/ USGlobalsat’s property.
(g) to a product or part that has been modified to alter functionality or capability without the written permission of Globalsat/ USGlobalsat; or (h) if any Globalsat/ USGlobalsat serial number has been removed or defaced. IMPORTANT: Do not open the hardware product. Opening the hardware product may cause damage that is not covered by this warranty. Only Globalsat/ USGlobalsat or an authorized service provider should perform service on this hardware product.
USGLOBALSAT DISCLAIMS ANY RESPRESENTATION THAT IT WILL BE ABLE TO REPAIR ANY PRODUCT UNDER THIS WARRANTY OR MAKE A PRODUCT EXCHANGE WITHOUT RISK TO OR LOSS OF PROGRAMS OR DATA. OBTAINING WARRANTY SERVICE Please access and review the online help resources referred to in the documentation accompanying this hardware product before seeking warranty service. If the product is still not functioning properly after making use of these resources, access the online website www.usglobalsat.
protect the contents and as a precaution against possible operational failures. Before you deliver your product for warranty service it is your responsibility to keep a separate backup copy of the contents, and disable any security passwords.
8. FCC Warning Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
