Sky Bridge Series SB-200 User Manual Global Bridge www.Globalbridge.co.kr CDMA WIRELESS Image & Display & Data Communication Bridge System SKYBRIDGE SB-200 FCC ID: 2AOJBSKYBRIDGESB200 USER MANUAL (Ver. 1.
Sky Bridge Series SB-200 User Manual WARNING & PRECAUTION This user manual is the basic manual for installation and operation and made for correct application of SKYBRIDGE WIRELESS BRIDGE product with CDMA technology. All users who install and use this CDMA wireless communication products must read and understand the contents of this manual.
Sky Bridge Series SB-200 User Manual Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Sky Bridge Series SB-200 User Manual The input voltage of wireless CDMA SKYBRIDGE products should be connected 48V DC and the input current should be supplied more than 1.5A. The power outlet must be grounded and never used with a heating device, air conditioner, magnetic field and radio wave generator Never use it with an electric motor, a generator, an antenna using another frequency, or a radio wave generator.
Sky Bridge Series SB-200 User Manual Product Introduction KEY FEATURE OF SKYBRIDGE® WIRELESS CDMA ● CSMA / CA + CDMA / TDMA - Convergence & multiple mobile communication technology - High-speed digital data wireless transmission and massive data wireless transmission ● High secured quality & unique IP security solution for ISM/WLAN Band range - WORLD First Wireless Solution Encrypted with Powerful Wireless CDMA Signal - Highly secured AES256/ARIA Encryption applied for all of wireless Data ● High efficie
Sky Bridge Series RF-100 User Manual Module Information Division Model Name Product Overview Description SKYBRIDGE RF-100 2.4G/5G Dual-band RF Transceiver Module for Wireless Communication Image Operating Frequency Antenna information Size RF Connector Input Voltage/Current Tx Power (OFDM mode, EVM<5.6%) 2410 ~ 2474 MHz / 5733 ~ 5813 MHz Type: Dipole antenna Peak gain: 2.4GHz- 2.5dBi / 5GHz- 4dBi 50mm x 55mm SMA Female Type for antenna connection 3.3V / 2.4GHz = 290 mA Typ. / 5GHz = 370 mA Typ. 2.
Sky Bridge Series SB-200 User Manual Product Description Front side of product SIGNAL : BLUE LINK : YELLOW POWER : RED Rear side of product DIP Switch for setting UART Connector for S/W Control Directional Bracket Top/Bottom side of product POWER: DC48V/1.
Sky Bridge Series SB-200 User Manual System map of wireless connection Sample map of Installation ( 1 : 1 ) SKYBRIDGE WIRELESS CDMA Transmitter(Tx) SKYBRIDGE WIRELESS CDMA Receiver(Rx) *** Please pre-test & pre-check Tx-Rx devices before installation on the ground.
Sky Bridge Series SB-200 User Manual System Configuration UTP/LAN 1km (3,280ft) IP CAM (FHD, UHD) IP CAM (FHD, UHD) 1:1 UTP/LAN UTP/LAN 2:1 1km (3,280ft) IP CAM (FHD, UHD) UHD/FHD 4K NVR UTP/LAN UHD/FHD NVR UTP/LAN Copyright© 2019 All rights reserved by Global Bridge
Sky Bridge Series SB-200 User Manual Description of Connection & Installation • SKYBRIDGE ® WIRELESS CDMA SYSTEM ◇ Checking power connection and advance operation 1) Before installation, be sure to connect the output power plug of the adapter supplied with the product to the DC jack of the wireless product so that the LED of each part normally operates as shown below. 2) Be sure to disconnect the power supply before connecting other wireless devices or digital devices.
Sky Bridge Series SB-200 User Manual ◇ Configuration of Wireless CH & Function setting • 8Pin DIP SWITCH Setting for each function DIP SW 1 Function Wireless Connection Control Setting ON OFF GPIO Pin Allocation AUTO MANUAL GPIO 10 2 Master(Rx) / Slave(Tx) Allocation Setting Master (Rx) Slave (Tx) GPIO 9 3 RF CH MODE Setting AUTO/FLEXIBLE MANUAL/FIXED GPIO 8 4 RF CH Frequency Setting DIP SW No.4 5 RF CH Frequency Setting DIP SW No.5 6 RF CH Frequency Setting DIP SW No.
Sky Bridge Series SB-200 User Manual Specification of products Product Model : SKYBRIDGE® (Model : SB-200) Host Interface ■ ■ ■ ■ ■ ■ ■ Binary CDMA+QPSK, DQPSK, 16/32/64QAM+TCM Modulation Single-Chip MAC and Baseband Processor system structure 16-bit, 60MHz DACs for Tx output & Differential ADCs for Rx input AMBA 2.0 Compliant Multi-bus System + KSX4650-1 Compliant High Speed/Full Speed/Huge Data Wireless Bridge - Max.
Sky Bridge Series SB-200 User Manual In accordance with the Consumer Damage Compensation Regulations, we guarantee the following wireless products. Serial No. year month date About Warranty Service by Manufacturer: • Free Warranty period : 1 year Free Service Paid Service 1. 2. 3. 4. 5. 6. 7.
Sky Bridge Series SB-200 User Manual CDMA(Code Division Multiple Access) Technology SKYBRIDGE® The Beginning of Iron-wall Wireless Security World Global Bridge www.globalbridge.co.kr USER MANUAL (Ver. 1.