User's Manual

GlobalTech China Ltd

Keyfob Instruction manual

Prepare by : Kendy

Date : 8, May, 2009

Technical Index :

Operation Power : 12Vdc/23A battery

Maximun transmitting power : less than 20mW

Working temperature : -10 to 70 degree

RF frequeny : 433.92MHz

RF Modulation : ASK Modulation

Instruction :

1 : Function

1.1 : The buttons on the Keyfob emitter are On / Off

1.2 : Press On, the Keyfob emitter will send the On instuction and the Led will flash one

1.2 : Press Off, the Keyfob emitter will send the Off instuction and the Led will flash one

2 : ID code select

Set matching 8 pole House Data Code on Keyfob emitter via Dip switches, ID code setting must

be same as the receiver unit

Battery installation :

The power of the Keyfob emitter is use 12V/23A battery, method of replacing battery: open the

housing cover then you can see the position of battery. When replace the new battery please

nsuring correct polarity is respected . After replace the new battery and then re

cover the housing, the

Keyfob emitter will back to operation status.

FCC Warning Statement

FCC NOTE :

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OT TV INTERFERENCE

CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENTN SUCH

MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions :

1. This device may not cause harmful interference, and

2. This device must accept any interference received, inculding interference that may cause

undersired operation.