OWNER’S MANUAL Walkie Talkies EN USER INSTRUCTION
This set included 2 walkie-talkie units: there are communication devices which operate on mobile radio frequencies. They come with 22 channels as well as back-lit LCD screen, enabling you to communicate over several Kilometers free-of –charge, up to 10 mile in open field. Note: Please read these user instructions Carefully before using the equipment and retain for future consultation! Specific Recommendations To avoid the risk of burns, do not use the device if the aerial is damage in any way.
Clean the device with a damp cloth. Avoid the use of cleaning agents and solvents. Do not modify the device in any way. In the event of damage occurring, ensure that the device us checked by a qualified professional. The device cannot be used to contact the emergency services.
Before Use the device Removing the belt clip Before insert batteries into the device, first pull the belt clip latch away from the device. Installing the Batteries 1, Slid down the battery compartment cover. 2, Insert 3* AAA Alkaline (Not included) 3, Position the batteries according to the polarity Making on the battery compartment. 4, After placing batteries into correct positions, Replace the battery cover.
PTT button, speak into the microphone in a normal tone of voice. Release the PTT button when you have finished transmitting. For others to receive your transmission, they must be on the same channel with you. Note: 1, The talking range will depend on your surroundings and environment. It will be affected by obstructions such as hills or buildings. 2, Don’t try to use two devices which are less Than 1.5m (5 feets) apart. Otherwise, you may experience interference.
7, VOX (Hands free function) Press the MENU button three times, the current VOX setting will flash on the display and the VOX icon will display. Press UP▲ button to set the VOX sensitivity level between 1~3 level (level 3 is the high sensitive level). Press down▼ button until “OF” appears on the display to turn VOX off. Press the PTT button to confirm and return to stand-by mode. In VOX mode, the radio will transmit a signal when it is activated by your voice or other sound around you.
11, Sending a call tone Press the PTT button one time quickly, the call tone will be transmitted on the setting channel. 12, Key Tone On/Off Press the MENU button 5 times, “TO” will be displayed. Press the UP▲/Down▼button disable the Key Tone ON/OFF. Press the PTT button to confirm your selection and return to the stand-by mode. 13, Roger Beep On/Off After the PTT button us released, the device will send out a roger beep to confirm that have stopped talking.
17, Technical specifications Frequency 462.5500~467.7125MHz Channel number 22 channels Sub-code CTCSS 38 Range Up to 10 mile in open field Battery type 3* AAA Alkaline each walkie talkie (not included) 18, How to reset the device? When you didn’t know what channel and sub-channel you are or the walkie talkies cannot communication each, you can reset the devices to Channel NO.1 and try to communication.
FCC Warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.