www.elmplus.com E-mail: service@elmplus.
48"W 30000-BTU Aluminum Propane Fire Pit with Cover Product has been CSA tested and certified. Read this manual before installing and operating this appliance. Failure to follow these instructions may result in electric shock, fire property, or personal injury. Do not store or use gasoline or other flammable liquids in vicinity of this appliance.
IMPORTANT SAFETY INFORMATION! IMPORTANT, FAILURE TO CAREFULLY READ, UNDERSTAND AND FOLLOW EVERY PART OF THIS DOCUMENT MAY RESULT IN PROPERTY DAMAGE, SERIOUS BODILY INJURY OR DEATH. DANGER • • • • FIRE OR EXPLOSION HAZARD If you smeII gas: Shut off gas to the appliance. Extinguish any open flame. If odor continues, Ieave the area immediateIy. After Ieaving the area, caII your gas supplier or fire department.
DANGER CARBON MONOXIDE HAZARD This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as a camper, tent, car or home. The minimum inlet gas supply pressure for the purpose of input adjustment: 25psi. WARNING Improper installation, adjustment, alteration, service or maintenance may cause property damage, serious bodily injury or death.
WARNING lf the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life. WARNING Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
• Do not use this appliance if any part has been under water. • Remove the battery when not using the appliance for an extended length of time. • Do not store a spare or disconnected liquid propane cylinder under or near this appliance. • After a period of storage, and/or non use, the propane appliance should be checked for gas leaks and burner obstructions before use. • This propane appliance must be used ONLY in a well ventilated space and shall not be used inside a building or garage.
• Never lean over the open appliance or place hands or fingers on the upper portion of an operational unit. • Do not rest feet on the appliance. • Do not enlarge valve orifices or burner ports when cleaning the valve or burner. • Liquid propane gas is not natural gas. This appliance is manufactured and preset for use with propane gas ONLY. • The conversion or attempted use of natural gas in a liquid propane unit or liquid propane gas in a natural gas unit is dangerous.
• This outdoor appliance is not to be installed or used in or on recreation vehicles and/or boats. • Always use in accordance with all applicable local, state and national codes. Contact your local fire department for details on outdoor burning. • Use the same precautions you would with any open fire when using this outdoor appliance. • Do not use this outdoor appliance until it is COMPLETELY assembled and all parts are securely fastened and tightened. • Do not store another LP gas tank within 10 feet (3.
Propane Characteristics: - Flammable, explosive under pressure, heavier than air and settles in pools in low areas. - In its natural state, propane has no odor. For your safety, an odorant has been added. - Contact with propane could burn the skin. • A dented or rusty liquid propane cylinder may be hazardous and should be checked by your gas supplier prior to use. • Do not use a liquid propane cylinder with a damaged valve and any other worn out parts.
thoroughly cleaned and inspected on a regular basis. Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts, or leaks, the hose must be replaced prior to the appliance being put into operation. • LP Tank used must include a collar to protect the cylinder valve. • The LP gas tank must have a listed overfilling prevention device (OPD) and a QCCI or Type I (CGA791) LP gas tank connection. • The LP gas tank should not be dropped or handled roughly.
• Keep gas appliance away from location where it can get excessively wet. Do not use gas appliance if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water. • This appliance shall be used only outdoors in a well-ventilated space and shall not be used in a building, garage or any other enclosed area.
b) If the burner valve is open prior to the LP gas cylinder service valve being opened, the connection will interpret this free flow of gas to be a leak. c) The connection safety feature will reduce gas flow from the regulator to the appliance to a minimal level. d) Be sure that the burner control valve is closed prior to opening the LP gas cylinder service valve to ensure that the connection flow limiting device is not triggered mistakenly.
CSA (Canadian Standards Association) certified to ANSI Z21.97-2017•CSA 2.41-2017 “Outdoor Decorative Gas Appliances”. Do not connect to a remote gas supply. Figure 1 SPECIFICATIONS INPUT 50,000 Btu/hr Propane Regulator Pressure 11 inches water column Clearances to combustible surfaces Sides: 72in. / 182.9cm Top: 48 in. / 121.
Item A B C D E F G H I J K L M N O P Q R S T 12 User Instruction Description Lid Table Top Control Knob (Preassmbled) Left Side Panel Back Side Panel Right Side Panel Door Frame Door Metal Stand M6X35mm Bolt M6X25mm Bolt M6 Flat Washer M6 Spring Washer Wrench Lava Rocks Battery (AAA) (Not included) PVC Cover Door Knob M4X25mm Screw M4 Flat Washer Qty 1 1 1 1 1 1 1 1 1 4 12 16 16 1 1 1 1 1 1 1
ASSEMBLY INSTRUCTIONS * Please keep this owner's manual for future reference. * Please unpack and identify all parts using the parts list provided. * Note: DO NOT tighten any bolts until all bolts have been started. STEP 1 Check that the Control Knob (C) for the gas supply system is turned to the "OFF" position before starting any assembly.
STEP 4 Attach the steel base to the bottom part of the Table Top (B) by using 4pcs M6X35mm Bolts (J), 4pcs M6 Flat Washer (L) and 4pcs M6 Spring Washer (M). STEP 5 Insert the Door (H) to Right Front Panel (F) and attach Door Knob (R) to the door by using M4X25mm screw (S) and M4 Flat Washer(T). STEP 6 Place propane gas tank (not included) into the Metal Stand (I). Make sure the gas tank sits on the metal stand completely.
STEP 8 Pour the box of Lava Rocks (O) into the fire pit around Table Top (B). DANGER WARNING: To ensure proper function, the guard on this burner should be free of lava rocks at all times. STEP 9 Close the door, put the Burner Cover (A) on the fire pit Table Top (C), then cover the fire pit with PVC Cover (Q) when not in use to protect it from the elements or when fire pit is cool COMPLETELY after the use. See "LP (Liquid Propane) gas supply connection" for tank connection.
LP (LIQUID PROPANE) GAS SUPPLY CONNECTION • Always confirm that the burner control knob is in the OFF position before connecting the gas supply. • Do not obstruct the flow of combustion air and ventilation air to the appliance. To Connect: 1. Ensure that there is no debris caught in the head of gas cylinder, head of the regulator valve. 2.
VISUAL CHECK Prior to each use, check the hose and valve for excessive wear or abrasions. LEAK TEST 1. Perform a leak test in a well ventilated area outside. 2. Make sure any open flames or cigarettes are extinguished. 3. Remove the battery. 4. Ensure the burner control knob is in the "OFF" position. 5. In a bowl, create a soap solution using 1 part water and 1 part liquid detergent. 6. Apply the soapy water solution to all connections. 7. Open LP tank valve. 8.
7. Once the appliance is lit, flame height can be changed by adjusting the burner control knob between the "High" and "Low" 8. Always check burner flames periodically to ensure proper operation. Flames should be mostly yellow with some blue for best performance. (See diagram) 9. Inspect the burner everytimes before use, if evident that the burner is damaged, or the burner can not lighting, pls contact the manufactory to get the appliance to replace it.
TO EXTINGUISH 1. Push and turn burner control knob to the "OFF" position. 2. Close the LP tank valve. 3. Disconnect the regulator from the LP tank to close the gas supply when not in use. 4. Make sure that the unit is completely cooled before touching any of the components or putting on the cover. ROUTINE CARE ● Keep your appliance free and clear from combustible materials. ● Visually inspect burner for obstructions, keep tank enclosure free and clear from debris.
Item Number:EPL1020 & EPL1021 Min.gas supply for input adj: Type of gas: Propane Normal Hourly Input: 30 ,000 BTU/hr (11.72 kw) For Outdoor Use Only. If Stored Indoors, Detach and Leave Cylinder Outdoors. Cover must be removed when burn is in opeartion. Minimum Clearance From Unit To Combustible Construction: 48” (121.9cm) from the top; 72” (182.9cm) from all sides and back. Manifold Pressure: 11 inch w.c. (2.74 kpa) 25 PSI Max.gas supply: 250 PSI ANS Z21.97-2017•CSA2.
PROBLEM Appliance emits a lot of black smoke when lit Sudden drop in gas flow Flame blow out Irregular flame pattern or flame does not come out of the entire length of the burner CAUSE CORRECTIVE ACTION Flame is obstructed at burner ports. Make sure all the gas burner ports are free of any lava rocks or debris to allow the gas to flow freely. Regulator hose is pinched. Check the regulator hose for bends or kinks. No gas flow. Check if gas cylinder is empty. If yes, replace.