Instructions / Assembly

ManualsBrandsGlitzhome ManualsFountains24.41 in. H Outdoor Polyresin 2-Tierd Stone-Like Birdbath Fountain

Assembly and Instructions

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the

product.

CAUTION: As with any large container of water, fountains are to be used carefully with adult supervision.

They are not intended to be used as “kid pools” and present a risk to small children and infants. Injury or

accidental drowning could result. In addition, as with any electrical appliance, make sure the pump plug

is dry before you plug it into an outlet, and make sure you are not standing in the water - electrical shock

could result. Filled fountain weighs a considerable amount. Make sure your set-up area can support at

least 300 lbs.

For best results – Install the fountain on a flat, level surface close to an electrical outlet.

Place the fountain in a location where any water spills or splashing will not reach any other electrical

equipment or cause damage.

Choose an appropriate location before installing the fountain. DO NOT lift or push/drag the water basin

to relocate the fountain when it’s filled with water. Empty the water basin before lifting.

Excessive weight or pressure on any of the fountain sections may cause it to tip or fall over. Keep pets

and children away from any of the fountain sections.

Some splashing may occur. To avoid injury from electrical shock, observe basic safety precautions and

comply with the following instructions:

The pump on the fountain has no user serviceable parts. Only an authorized service representative

should service the pump. Do not open the sealed pump housing as this may result in electrical shock.

Refer to enclosed pump maintenance guide for cleaning.

 Always unplug the pump from the electric outlet before cleaning and handling.

 Use with clean water only. Do not place it in other liquids. Do not allow the pump to run dry.

 An adult should supervise children when they are around the pump.

 Use the proper power source as indicated on the pump label.

 Equip the electrical power for the pump with a ground fault circuit interrupter (GFCI).

 Keep the fountain away from high temperatures or heat sources.

 Do not use the pump in water above 86°F.

 Disconnect the power cord from the outlet by holding the plug. Do not lift, carry, or pull the pump by

the power cord.

 If the entire fountain falls into the water accidentally, turn off the circuit breaker immediately.

 If any leakage occurs around the pump housing, turn off the circuit breaker immediately and have

the pump serviced by a registered technician.

 Do not operate the fountain if the pump has been dropped or has a damaged power cord or plug. Do

not replace the power cord.

 Keep the plug dry. Do not expose the plug to water or steam. Do not use the pump in swimming pool

or marine area.

 If the plug or the wall receptacle gets wet due to water dripping down the power cord or for any other

reason, do not remove the plug from the wall outlet until the circuit breaker is turned off.

NOTE: Allow the pump power cord to hang at

a lower level than the wall outlet to form

a “drip loop.” This will help prevent water

from dripping down the power cord and

getting into the wall outlet.

GFCI

DRIP LOOP

Page 1

Summary of content (3 pages)

PAGE 1
Assembly and Instructions SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. CAUTION: As with any large container of water, fountains are to be used carefully with adult supervision. They are not intended to be used as “kid pools” and present a risk to small children and infants. Injury or accidental drowning could result.
PAGE 2
    Do not expose the pump to direct sunlight or to low temperatures for any period of time. Use only a UL-approved extension cord of the correct rating to avoid overheating. Do not use attachments that are not provided by the manufacturer since they may cause an unsafe condition. Do not use the pump for anything other than its intended use. ASSEMBLY INSTRUCTIONS Put the big bowl on to the pedestal and screw it tightly. Make the pump cable out from the bottom of pedestal.
PAGE 3
Pressure-Casing Outlet Pump Housing Control Valve Outer Cover Rotor Absorb Cap Filtering Cover TROUBLESHOOTING PROBLEM Fountain is not pumping water. POSSIBLE CAUSE CORRECTIVE ACTION 1. Pump is not covered with water. 2. Pump or fountain is blocked. 1. Add more water to the reservoir. 2. Disconnect fountain from power source, remove any obstruction, and clean bowl and tubing. 3.