User's Manual

User manual

Introduction

Congratulations on receiving your GL-MT300A. As part of our Green Initiative, we do not include printed user

documentation with our product packaging. This policy saves paper, lowers shipping costs, reduces carbon

emissions and results in a cleaner environment.

Documentation

All product and accessory documentation can be found at the GLI Support Centre: http://www.gl-inet.com/docs

On this site you will gain access to GLI technical resources and information about GLI products. To use your new

GLI Mini Router you will need to follow the simple steps which you can see from

http://www.gl-inet.com/docs/wiki/#!mini/index.md

Default System Settings

Product

LAN Default IP Address LAN Fall-back IP Address

GL-AR300MD DHCP 192.168.8.1

Initial Set-up

Interfaces described as followed:

Power to the GLI Mini Router is provided by connect the power lead (supplied) to the power adaptor (buy

separately) and then to the power interface on the GLI Mini Router.

Once power is provided to the GLI Mini Router the LED’s will provide status on its operation based on the

following:

LED

Indicator

Description

LED 1 (Power) Green solid Power is applied

LED 2 (Customized) Customized This is customized LED.

LED 3 (WiFi connection) Red

Indicates WiFi signal (solid) and

data transfer (flashing).

PAGE 1
User manual Introduction Congratulations on receiving your GL-MT300A. As part of our Green Initiative, we do not include printed user documentation with our product packaging. This policy saves paper, lowers shipping costs, reduces carbon emissions and results in a cleaner environment. Documentation All product and accessory documentation can be found at the GLI Support Centre: http://www.gl-inet.com/docs On this site you will gain access to GLI technical resources and information about GLI products.
PAGE 2
Button Definition Press the Reset button to toggle the WiFi signal ON or OFF. Press and hold the Reset button for at least 8 seconds, then release your finger to reset the router to factory default state. Wait until the router reboots, which could take about 3 minutes. The function of “switch” is configurable by user. FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference.