User Manual GK Wireless System GKWS052 GKWR052 The GK Wireless system is a wireless replacement for a 13-pin DIN cable between a Roland GK3 divided pickup and a guitar synthesizer. It prevents stumbling over the long cable, provides a more robust connection and gives you more freedom of movement.
Table of Contents Important safety instructions .................................................................................................................. 3 Precautions .......................................................................................................................................... 3 Waste Electrical and Electronic Equipment Directive ......................................................................... 3 What is in the box? ..............................................
Important safety instructions Precautions WARNING - When using electric products, basic precautions should always be followed, including the following: • • READ this user manual KEEP this user manual for reference • • • • • • HEED all warnings FOLLOW all instructions DO NOT use this device near water, rain or moisture CLEAN ONLY with a dry cloth DO NOT block any ventilation openings DO NOT store near any heat sources such as open flames, radiators, stoves, or other apparatus that generate heat PROTECT th
What is in the box? Included items I1 GK Wireless Sender Model: GKWS052 I2 GK Wireless Receiver Model: GKWR052 I3 Footswitch I4 Receiver 13-pin standard DIN cable I5 Jack cable I6 2x RP-SMA antenna, 3dBi Optional accessories (buy separately) O1 Sender 13-pin standard DIN cable O2 Sender 13-pin locking DIN cable O3 Sender 13-pin right-angle DIN cable GK Wireless System User Manual 4
Product Overview GK Wireless Sender RF LEDs (blue) Power LED (green) Pair button Power switch Ventilation holes 13 pin DIN input connector GK Wireless Receiver RP-SMA antenna connectors RF LEDs (blue) Power LED (green) Power switch 13 pin DIN output connector Power connector (9V DC, 300 mA, center negative) GK Wireless System Footswitch and Amplifier 6.
Power on/off Batteries for the sender Open the battery cover on the back of the sender to insert two protected 18650 rechargeable batteries with button top (not included). It is recommended to use 3200 mAh or higher batteries. Only use protected 18650 batteries with a button top. Unprotected batteries have no current protection and may cause a fire in case of a short circuit. Remove batteries when sender is not in use.
Setting up the GK Wireless System 1. Insert fully charged 18650 protected batteries with button top in the sender. 2. Connect the sender DIN input to your GK3 (or compatible) with one of the optional 13-pin DIN cables. 3. The sender comes with a belt clip. Clip the sender to your guitar strap during use. The sender transmits radio waves. Keep the sender at least 20cm (7.85 inches) away from your body. 4. Connect a power adapter to the receiver connector 5.
Main Specifications Frequency band 2.4 GHz ISM license free band Tuning bandwidth 2400-2483 MHz Modulation scheme Other Wideband with Adaptive Frequency Hopping, 18 channels @ 4 MHz bandwidth Antenna type and gain This radio transmitter [IC: 27640-GKWR052] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated.
Service When you need service, contact BluCoE via the website: https://www.blucoe.eu/contact Office address: BlueCollars BV Beemdheuvel 28 5685 AE Best The Netherlands Warrantee Warrantee is one year after purchase.
Certifications The wireless system may be operated in countries that accept at least one of the following markings. CE / UKCA This product meets the Essential Requirements of all relevant European directives and is eligible for CE and UKCA marking. Hereby, BlueCollars BV declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.blucoe.
