Installation Guide

Single Hole
Application
3-Hole
Application
y.
ff at the stop valve.
· Every once in a while, please rinse the faucet with lukewarm soapwater, and wipe it clean with a soft duster cloth.
Please avoid any abrasive cleaners, steel wools, or corrosive chemicals.
· To insure proper installation, please read the following instructions carefull
· Please make sure that the water supply has been shut o
BEFORE INSTALLATION
1.Install square Gasket ② onto Faucet Body ①.
Slide single hole faucet through the sink mounting hole.
7
1
6
5
4
3
2
6
5
4
3
2
8
9
8
9
Note: Escutcheon is included for 3-Hole applications. ⑦
2.Place Stainless Steel Washer ④ and Rubber
Washer ③ onto Mounting Studs ⑥ under the
sink, and tighten the Mounting Nuts ⑤ securely
as shown.
3.Connect and screw on the Supply Hoses ⑧ to Valves ⑨.
4.Turn on faucet to check for leaks.