User's Manual

ManualsBrandsGIT ManualsElectronicsGOCAR

Table Of Contents

说明书

USER MANUAL for CODING CAR

1. Unplugged Mode

(1) Card Coding

①Turn the power on开机

② Scan the “Initialization of Sensor” card

- Push the front-top of Coding car for 3 time in a sec, on the card.

③ Scan the “Start of Card Coding” card.

- Push the front-top of Coding car for 1 time, on the card.

④ Scan the coding cards in order and lastly scan “End of Card Coding” card

- Push the front-top of Coding car for 1 time, on the card.

⑤ Put the coding car on the ground, and Push the front-top of Coding car for three seconds.

⑥ It will be terminated automatically after action for coding.

Summary of content (4 pages)

PAGE 1
USER MANUAL for CODING CAR 1. Unplugged Mode (1) Card Coding ①Turn the power on开机 ② Scan the “Initialization of Sensor” card - Push the front-top of Coding car for 3 time in a sec, on the card. ③ Scan the “Start of Card Coding” card. - Push the front-top of Coding car for 1 time, on the card. ④ Scan the coding cards in order and lastly scan “End of Card Coding” card - Push the front-top of Coding car for 1 time, on the card.
PAGE 2
(2) Line Coding ① Turn the power on 开机 ② Scan the “Start of Line Coding” card - Push the front-top of Coding car for 3 time in a sec, on the card. ③ Put the coding car on the Line ④ The Line coding will start in 2~3 seconds automatically. (3) Piano Coding ①Turn the power on ② Scan the “Start of Piano Coding” card - Push the front-top of Coding car for 3 time in a sec, on the card.
PAGE 3
2. Plugged Mode (1) Bluetooth – Remote Control(RC) ①Turn the power on ② Run the App on smart device(Tablet or Smartphone etc.) ③ Select the Coding Car on the list and Connect it through Bluetooth ④ Enter “Drive Menu” ⑤ Control the coding car using lever on the screen. (2) Bluetooth – Block Coding ①Turn the power on ② Run the App on smart device(Tablet or Smartphone etc.
PAGE 4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.