Purpose and principle of operation of the GRIDLOCK WINNER RADIO electric ball valve actuator The GRIDLOCK WINNER RADIO electric ball valve actuator ensures the safety of water supply and heating systems, In the event of a'leak the device shuts off the oversupply, and alo notifies of an emergency with sound and light signals. When water gets on the electrodes of the wired WAP sensor other FURLONG wireless sensor, the water supply is automatically shutoff, and corresponding sound and light signals are issued.
ATTENTION When os warming signals received; the batteries in the electric actuator must be replaced see page 13) The battery charge level automatic control function works only with the autonomous operation of the electric actuator, housecleaning function: With long-term operation:of the equipment, problems often arise with the deposition of salts and dirt in the pipes and in the actuator, the so called scaling.
Terminals +, GND, #3, our Terminals INP, FUN, CHI, CM2 Perjurer {2} for connecting the QUY and FUN terminals the actuator housing Photo & Alec actuator for bivalve control with cover removed CLOSE control button and CLOSED, ALARM LED OPEN control button and OPEN, RADIO LED 2 Go BALM wham GHDLDCK WINNER RADIO pee nv Ear LE. Wall C £ Jumper{l) for power on/off SET/RESET button Hot Z.
Lae Simultaneous pressing of the OPEN and CLOSE buttons leads to light and sound indication of the electric bail valve actuator. First, information about thermostat the valve closeness) misplayed for? consent, then the standby mode is turned on, if there are Ho emergency situations. In case of any abnormal situation an indication occurs in accordance with the table "Emergency mode, Light and sound indication of the electric actuator mode (page 5).
Light indication of the state of the electric actuator’s radio channel: green RADIO LED green: RADIO LED [I standby mode, the radio channel is monitored move every Second flashily green RADIO LED]. In flasher Seton the presence of signal from wireless senior the command is received, interpreted and executed. warmongering channelization The electric actuator absinthe familiarization {registration mode with new flashing leakage sensors FURLONG Emergency mode.
Photo 8. Insert the sensor Photo 9, Terminals for connecting Photo 10 Connecting the sensor wire to the Photo 11, Connecting the sensor Wire into the table gland Wired sensory = INP GND meting connector of the gentile Initiator toilette lc Tidewater Installation and connection of WSP wired water leakage sensors stall water leak ope sensors in places where water is most kel to appear In the event of leaks = for example, on the floor under the sink, bathtub, Washing machine.
Photo 12, Wireless stentorian softening Riotous 13, Aligning the protrusions Photo: 14, Finding to the floor Phis to 15: Press the SET/RESET element nonwhite of the eclectic ventilator Connecting WOOLONGONG wireless water leakage sensors ATTENTION! 10 WOOLONGONG wireless sensors can be connected 1a one GRIDLOCK WINNER RADIO electric ball valve actuator.
Photo 16. Switch for Photo 17 Connecting o Photo 18. Connecting wired switch Photo 19: GRIDLOCK WINNER ONG external wiring wired passivity to the electric aerator touchscreen wireless radio remote control Terminals for connecting a switch for remote opening /Shutting off the water supply: FUN GND Shorting the FUN Gnd Indeterminate will close the actuator, opening these terminals will open the actuator) (Photo 18% For connection, iris recommended to use a twisted pair cable; eg: FIP 2x230.35, UTP 212x0.
For the correct operation of the GRIDLOCK radio remote control box, you need to perform the familiarization {registration} procedure of the GRIDLOCK WINNER LONG radio remote control box with the GRIDLOCK WINNER RADIO electric actuator «Press the SET/RESET button of the electric actuator (Photos 7 and 15) and hold it for about 3 seconds O ee {but not more than seconds!) until the green RADIO LED starts blinking, = Briefly touch the touch panel of the radio remote control bos with your fingering the area of t
uninstalling the radio remote control: insert the radio remote control housing into the special plastic frame {4}. Press the radio remote control until it clicks: *To remove the radio remote control, vou need special Unshaped bracket conclude, which must be Inserted Into the special holes (1) on the underside of the panel case.
*12y =12v Photo 21: External AC 220 power PHO 22: Electric littoral connector terminals Photo 23: Connecting on external supply unit of the electric-actuator far connecting an external #12V power supply +#12V power supply tithe noting connector of the eclectic actuator Connecting the GRIDLOCK WINNER RADIO device to an external power supply Investigated operating time of the GRIDLOCK WINNER RADIO electric ball valve actuator based ond built-Ln batteries type AN 3000 rah Lithium J in standby mode [attn-cranki
Photo: 24. Electric actuator with detached ball Elliot 25.
Philby 30. Electric: itu tor with top voter removed Alioth 31 Contact plate is removed, batteries cane replaced Installing and replacing batteries Tote place the batteries: *Disconnect the electric actuator from the ball valve (Photo 24} « Unscrew the sellotaping screws on the cover of the electric actuator.
ELL statement: This device complies with Part 15: 0b the FCC Rules. Operation ls subject tithe following two conditions: {1) This device may not cause noninterference, and {2} This device must accent any interference received, Including interference that may cause undesired operation Warning: Transmogrification not expressive approved by the party responsible for compliance could void the user's authority to operate the equipment.
Technical specifications Working radio-frequency 915 MHz Type of radio sensors ERELONG Number of connected radio sensors 10 pieces Type of wired sensors WSP Number of connected wired sensors 10 pieces Valve diameter Wn 17 Inch Workingwoman pressure 4b bar End thread type pipe G. G17 Ball valve material brass CWe17N Working fluids water or any fluid compatible with P.
i" DRUGSTORES LLC 8 (495) 585-12-59 8 (498) 720-52-28 ENGINEERING SAFETY SYSTEMS 8 (495) 120-50-02 8 (800) 707-51-58 {free in Russia) Warranty Certificate www.gidrolock.ru Dear customer! Thai you for purchasing our product The GRIDLOCK WINNER RADIO system will serve you for a long time and will protect you from troubles associated with accidents in bathwater supply and heating systems; The warranty period for the GRIDLOCK WINNER RADIO system 156 years from the date of sale.