Always there to help you Register your product and get support at www.philips.
Contents 1 Important 2 2 Safety 2 Your clock radio 4 4 4 4 3 Get started 6 6 6 6 4 Listen to FM radio 7 7 7 7 7 7 5 Use Bluetooth devices 8 8 8 9 9 9 Introduction What's in the box Overview of the clock radio Install battery Connect power Set clock Tune to FM radio stations Store FM radio stations automatically Store FM radio stations manually Select a preset radio station Adjust volume Connect a device Play audio from Bluetooth-enabled device Bluetooth icon status Clear the pairing informatio
1 Important Safety Know these safety symbols g Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. i Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. j Only use attachments/accessories specified by the manufacturer.
information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org. q Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable. Note •• The type plate is located on the bottom of the apparatus.
2 Your clock radio a Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. b • • • Set Alarm 1. View alarm settings. Activate or deactivate alarm timer. • Set sleep timer. c RADIO • Turn the radio on or off. d SNOOZE/BRIGHTNESS • Snooze the alarm. • Adjust display brightness.
i + PRESET/ MIN • Adjust minute. • Select preset radio stations. j SET TIME/12/24 HR • Press to enter timer setting mode. • Press and hold to set 12 or 24 time format. k + TUNING/ HR • Adjust hour. • Tune to FM radio stations. l Display panel m VOL knob • Adjust volume. n FM ANT • Improve FM reception. o Power plug • Connect AC power. p USB socket • Charge your mobile devices.
3 Get started Always follow the instructions in this chapter in sequence. Install battery Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type. •• The batteries contain chemical substances, so they should be disposed of properly. You can only use AC power as power supply. The battery can only back up clock and alarm settings.
4 Listen to FM radio Store FM radio stations manually Note •• You can store a maximum of 20 FM radio stations. Tune to FM radio stations Tip •• Position the antenna as far as possible from any electrical appliances. •• For better reception, fully extend and adjust the position of the antenna. 1 2 3 Press RADIO to turn on FM radio. »» is displayed. Press and hold + TUNING/ HR - for two seconds. »» The clock radio tunes to a station with strong reception automatically.
5 Use Bluetooth devices With this clock radio, you can listen to audio from Bluetooth-enabled devices and control the incoming call through Bluetooth. Connect a device Note Note •• If your Bluetooth device has been paired with AJT4400B before, you just need to find out [AJT4400B] on your Bluetooth menu, then start the connection. To disconnect the Bluetooth-enabled device: • Press and hold for 3 seconds; • Disable Bluetooth on your device; or • Move the device beyond the communication range.
Bluetooth icon status Bluetooth icon Description Flashing quickly (at 1Hz) Connecting or waiting for connection Pairing Flash slowly (at 2Hz, with single beep) Solid Bluetooth icon Bluetooth icon off Connected Bluetooth function is turned off Clear the pairing information In Bluetooth mode, press and hold for 10 seconds. »» [BT RESET] scrolls on the display panel, then all the Bluetooth pairing information is erased.
6 Set alarm timer Set alarm Note •• Make sure that the clock is set correctly. 2 3 4 5 6 Press and hold or for two seconds to activate alarm setting mode. »» The hour and minute digits and the alarm icon ( or ) begin to blink. Press + TUNING/ HR - to set hour. Press + PRESET/ MIN - to set minute. Press or to confirm. »» [buz] (buzzer) or your last listened frequency blinks. Press + TUNING/ HR - or + PRESET/ MIN - to select an alarm source: buzzer or your last listened channel.
7 Other features Note •• The maximum current for USB charging is 1A. •• It is not guaranteed to charge all devices with this product. Set sleep timer This clock radio can switch to standby mode automatically after a preset period. • Press repeatedly to select the sleep timer period (in minutes). 15 30 60 90 Adjust display brightness Press BRIGHTNESS repeatedly to select different brightness levels.
8 Product information Battery Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 W RMS Tuner Tuning Range (FM) Tuning Grid Search Selectivity Total Harmonic Distortion Signal to Noise Ratio 87.5 - 108 MHz 100 KHz <28 dBf <3% >55 dB Bluetooth Bluetooth version Supported profiles Range V3.
9 Troubleshooting Warning •• Never remove the casing of this device. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.
10 Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. Compliance Notice for the USA and Canada This device complies with Part 15 of the FCC Rules and RSS standard of Industry Canada.
• Please visit www.call2recycle.org for additional information on a recycling center in your area for rechargeable batteries. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company.
2015 © WOOX Innovations Limited. All rights reserved. Philips and the Philips’ Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used by WOOX Innovations Limited under license from Koninklijke Philips N.V.
Addendum Sheet FR Conformité Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnemen AJT4400B_37_Addendum_V1.