User's Manual

JJ--RC-F8 Remote control Manual

一、 type: remote control

二、 IC：HCS301

三、 Modulation: ASK

四、 The frequency range: 433.92MHz ± 100KHz

五、 The number of channels: 1

六、 Frequency stabilization mode: sound frequency

stabilization

七、 Antenna: on-board PCB antenna 0dBi

八、 Operating voltage: 6V

九、 Working current: 10mA

PAGE 1
JJ--RC-F8 Remote control Manual 一、 type: remote control 二、 IC：HCS301 三、 Modulation: ASK 四、 The frequency range: 433.
PAGE 2
十、 Photo：十一、 Operation: The remote control uses HCS301 encoder chip, ensuring every launch of the code and the last launch of the code is not repeated, which can prevent the code copied by others, resulting in security issues. When the user presses the button shown in the figure, when shown the LED will light, indicating the success of this launch, when the user stops pressing the key after the LED lights burn out, firing stopped.
PAGE 3
FCC ID: WSYJJ-RC-F8 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.