User's Manual

INSTRUCTION OF SINGLE CHANNEL REMOTE CONTROL
SYSTEM
z VOLTAGE：12V/24V optional
z FREQUENCY：433.92MHZ±100K
z CHANNEL：1
z CHARACTERISTICS：
 APPLICATION RANGE: gard agaist theft, gate opener, motor etc.
 This system can memory about 100 remotes.
 If the receiver is not in the state of learning new code, but it gets same code(and
same format) of the remote, learning LED will flash to indicate that the remote
can work with the receiver.
z WORKING INSTRUCTION：press the button, dry contact activates 2 minutes. In
the first 5 seconds, any other control signals will be invalid. After 5 seconds if
you press the button again, dry contact will disconnect. If there’s no operation in
the first 2 minutes, dry contact will open 2 minutes later.
 LEARNING CODE：
Short press learning button on PCB, LED will flash and keep lighting, now you can
learn new code. If the code is learnt successfully, LED will turn off. If it doesn’t learn
new code in 5 seconds, LED will turn off and stop learning.
z REMOVE CODE:
Press learning button for 10 seconds, LED will flash 5 times and turn off. Then all
the existing codes will be removed.