Installation Instructions
Garage Door Keypad Compatible Opener with Yellow Learn Button ONLY
NOTE 1: Factory set PIN code 1111# for 1st channel, 2222# for 2nd channel, 3333# for 3rd channel.
NOTE 2: If you want to change the existing PIN code, please go "FACTORY RESTORE" reset the keypad
and then repeat the "PROGRAMMING".
PROGRAMMING
1 2 3
4 5 6
7 8 9
0 #
OR
OR
1111#
(1st -Ch)
2222#
(2nd -Ch)
3333#
(3rd -Ch)
Start with garage door CLOSED.
Please read instructions thoroughly BEFORE beginning.
Install the battery and program the keypad prior to installation.
Our Garage Door Keyless Entry Keypad can programmed the Chamberlain, Sears Craftsman, Liftmaster, Master Mechanic, Do It, Stanley,
Wayne Dalton or Linear etc garage door openers has a Yellow learn button. Please ENSURE your garage door opener type has a YELLOW
learn button on the motor unit or external receiver, otherwise it will not work.
The keypad has 3 channels,it can control up 3 garage door opener independently.
* The new PIN code you set MUST be remembered,you’d better
to write it on the underline!
* Then the new PIN code that’s the existing PIN code.
If you get something wrong when programming or entry PIN code and can not proceed with any operation,
you could reset the keypad.
FACTORY RESET
Now the keypad has restore Factory Set model with PIN code 1111# for 1st channel,2222# for 2nd channel and
3333# for 3rd channel. And you need to re-program it again to match the garage door opener.
Remove the battery cover and you will see a Reset Button.Press and hold this Reset Button for about 6s until you hear
a buzzer sound and the backlight LED will off, then release the button.It mean the keypad has been reset successfully.
1 2 3
4 5 6
7 8 9
0 #
Slide case
Button
9V Battery
Reset Button
Backlight
Locate the Learn Button on the garage door opener motor unit or external receiver. Determine your garage door opener type
has a YELLOW learn button,and it utilizes Security+ 2.0 and transmits on 310,315 or 390 MHZ. Manufactured since 2011.
Press and hold the and button at the same time
for enter into programming model.
*
#
1 2 3
4 5 6
7 8 9
0 #
1
Select the channel and set a 4-digits new PIN code.
OR
OR
2
The Learn LED will light on within 30 seconds...
Learn Button
Yellow
Press and release the Yellow learn button on garage door opener.
3
Press the existing PIN code # again,
then the opener will activate.
4
1 2 3
4 5 6
7 8 9
0 #
To test and use, just enter the PIN code again.
5
* If opener does not function,please reset the keypad and repeat above programming.
* In order to distinguish different channels,we recommended set the different PIN code for each channel.
For 1st channel: Press 1111#, then press new PIN code #.
For 2nd channel: Press 2222#, then press new PIN code #.
For 3rd channel: Press 3333#, then press new PIN code #.
Click
Click
1 2 3
4 5 6
7 8 9
0 #
_ _ _ _
PIN Code
#
The opener light bulb will blink once OR two clicks are heard.
The garage door MUST be in the fully CLOSED position
during installation.
NEVER permit children to operate or play with keypad.
CAUTION