Installation Guide

Please leave this sheet and warranty for the customer for future reference
Maintenance: Clean with warm water, soft cotton
cloth and non-abrasive liquid dish soap. Towel dry.
Never use acids, harsh abrasives, detergents, or
products containing chlorides on any parts of this
product.
Hole Diameters are
7
8
" minimum to 1
3
4
" maximum.
Maximum deck thickness is 1
1
8
".
This faucet comes completely assembled and water tested.
Tools required-channel lock pliers (or pipe wrench), basin wrench, small
crescent wrench and silicone sealant.
.
Please leave this sheet and warranty for the customer for future reference
Insert lift rod (6A) into strap
(6B) and tighten screw (6C).
Step 6
Figure 1
Step 3
Install Pop-up Assembly. Remove
stopper (3A) and flange (3B).
Screw nut (3C) all the way down.
Push gasket (3D) down.
3D
3C
3A
3B
Page 2Page 1
Step 4
Apply silicone sealant to the
underside of flange (4A). Insert
body (4B) into sink. Screw flange
onto body. Pivot hole (4C) must
face the back of the sink. Tighten
nut (4D), do not overtighten. Clean
excess silicone sealant.
Shut off water supply prior to beginning installation.
Make connections to water lines. Use 1/2" I.P.S.
faucet connections (2A, not included) or use
coupling nuts (2C, not included) with 3/8"
O.D.ball-nose riser (2B). Use wrenches to tighten
connections. Do not overtighten.
Step 2
Step 1
Insert faucet assembly (1A) through sink with
the base plate (1B) above the sink. Secure the
faucet assembly (1A) to the sink using the
mounting nuts (1C) provided.
Note: If t
he sink is uneven, use silicone under
the base plate (1B).
Step 5
Remove pivot nut (5A). Install
horizontal rod (5B) and stopper
(5C) as non-removable (5D). Hand
tighten pivot nut (5A). Attach
horizontal rod to strap (5E) using
clip (5F).
RP40027*
Pop-up Assembly
Less Lift Rod
Important: After installation is
complete, remove aerator (7A) with
a coin (7B) and turn faucet on for
two minutes to flush out any debris
from the water lines. While water is
running, check for leaks. Replace
aerator (7A).
Step 7
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Brushed Nickel
*Specify Finish
Finish Codes
BN
For additional assistance or service call: 1-888-560-5222 USA 8:30 a.m. to 5:30 p.m. EST Monday-Friday
Parts
1A
1B
1C
2B
2C
2A
4A
4D
4B
4C
5C
5D
5E
5F
5A
5B
6A
6C
6B
7A
7B
RP50002
Set Screw
RP13354*
Handle H
RP50003
Connector
RP70435
Bonnet
RP20013
Cartridge H
RP20014
Cartridge C
RP64123
Washer
RP30131
Aerator
RP56001
Mounting nut
RP40194*
Lift Rod
RP13355*
Handle C
For additional assistance or service call: 1-888-560-5222 USA 8:30 a.m. to 5:30 p.m. EST Monday-Friday