Installation Instructions

ManualsBrandsGhost Contro ManualsElectronicsGhost Control Wireless Transmitter

WIRELESS VEHICLE SENSOR

OVERVIEW

Wireless Vehicle Sensor

Control Unit

Minimum of 20 Feet

Maximum of 100 Feet

from control board

sensor cable

WARNING: This product can expose you

to chemicals including lead, which is known

to the State of California to cause cancer.

For more information, go to

www.P65Warnings.ca.gov

WARNING: DO NOT USE THIS DEVICE WITH LIVESTOCK OR OTHER ANIMALS.

NOTE

PLEASE READ THE MANUFACTURERS INSTRUCTIONS INCLUDED WITH THIS ITEM PRIOR TO INSTALLING.

IMPORTANT ITEMS REQUIRED G

Two (2) C Alkaline Batteries are required and not included. One (1) Ghost Controls Transmitter that already operates the gate.

KIT CONTENTS:

■ 1 – Control Unit with control board (to be installed above ground)

■ 1 – Sensor Probe with 10’ cable (to be buried below ground)

■ 1 – 12” PVC Pipe

PREPARING FOR INSTALLATION:

■ Must be located at least 20ft beyond the path of the moving gate.

■ Must be located where the driver of the approaching vehicle has clear view of the gate.

■ Bury probe approximately 12” deep and as close to the driveway as possible for maximum detection of moving vehicles.

■ The Control Unit must be at least 6” above ground.

■ The Control Unit also should be with 100 ft of the Ghost Controls receiver/control box.

NOTE

The actuator distance may vary depending on Radio Frequency interference at each installation site.

Avoid installing the unit near power lines, transformers or running motors.

PVC Pipe

Control Unit

Sensor Probe

Summary of content (4 pages)

PAGE 1
WIRELESS VEHICLE SENSOR OVERVIEW WARNING: DO NOT USE THIS DEVICE WITH LIVESTOCK OR OTHER ANIMALS. NOTE PLEASE READ THE MANUFACTURERS INSTRUCTIONS INCLUDED WITH THIS ITEM PRIOR TO INSTALLING. IMPORTANT ITEMS REQUIRED G Two (2) C Alkaline Batteries are required and not included. One (1) Ghost Controls Transmitter that already operates the gate.
PAGE 2
SETTING UP YOUR WIRELESS VEHICLE CONTROL UNIT BOARD: BEFORE CONTINUING MAKE SURE YOUR GATE IS CLOSED. TURN THE GATE OFF BY TURNING THE SWITCH TO THE OFF POSITION ON THE BOTTOM OF THE CONTROL BOX. *The following steps can be performed indoors BEFORE digging and burying the Sensor Probe. a. Remove the cover on Control Unit by sliding it upward to access the Control Unit board and install the two (2) batteries. Shown below in Example A. b. Insert/Install the batteries. Shown below in Example B. Example A.
PAGE 3
TESTING THE CONTROL UNIT BOARD: a. Move some type of steel object like a screw driver along the sensor (shown). b. Observe that the yellow “DETECT” LED turns ON and the green “XMIT” LED is blinking for 1 second. INSTALLING YOUR WIRELESS VEHICLE SENSOR PROBE AND CONTROL UNIT: XMIT LED (Green) blinking for 1 second Control Unit Board Steel Object Sensor Probe STEP 1: PLAN YOUR INSTALLATION LOCATION FOR THE DETECT LED (Yellow) stays on for 1 second BEST RADIO FREQUENCY RANGE a.
PAGE 4
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: ■■ This device may not cause harmful interference ■■ This device must accept any interference received, including interference that may cause undesired operation. WARNING G Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.