Assembly Instructions Caution : You must read this before you proceed DINING CHAIR Part List Label Picture Description QTY A Leg - A 1 B Leg - B 1 C Cushion Chair Seat 1 D Corner Block 2 Page 1 of 7
Hardware Label Picture Description QTY ① JCBC W Screw M7 x 40mm 1 ② JCBC Screw M6 x 60mm 4 ③ FH Screw #8 x 25mm 8 ④ Allen Key M4 1 Assembly Preparation Before Beginning Assembly: Page 2 of 7
Assembly Steps Overview Cushion Chair Seat Leg (B) Leg (A) This Dining Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 1.1 1.2 1.1 Crossover the Leg Up (A) and Leg Down (B) as shown. Make sure the leg right position front and back. 1.
Step 2 Place the Cushion Chair Seat (C) on the table as shown for easy assembly, and place the assembled part that finished in Step 1 on the cushion seat. Then, fix the Leg with JCBC Bolt ② using Allen Key ④. DO NOT FULLY TIGHTEN BOLT. Step 3 Fix the Leg with JCBC W Bolt ① using Allen Key ④ at center of the assembled part DO NOT FULLY TIGHTEN BOLT.
Step 4 Place the Corner Block (D) at the center leg as shown. Then, fix the Corner Block (D) with Screws ③ using Screwdriver (not provided). Repeat the step for another Corner Block. DO NOT FULLY TIGHTEN THE BOLT AND SCREWS NOW.
Place the dining chair on a Level Surface to check if it wobbles. If it wobbles, lift the dining chair some 30cm to 50cm high from the ground, keep your feet and toes well away from the drop zone, and drop the dining chair freely and vertically with the four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment. Test again for evenness on Level Surface. If no wobbles are found, proceed to tighten all the Bolts.
Care & Maintenance Page 7 of 7