Assembly Instructions Caution : You must read this before you proceed DINING CHAIR Part List Label Picture Description QTY A Chair Back 1 B Front Leg 1 C Side Stretcher (R) 1 D Side Stretcher (L) 1 E Side Rail (R) 1 F Side Rail (L) 1 G Cusion Seat 1 Page 1 of 7
Hardware Label Picture Description QTY ① JCBC M6 x 50mm + S/W M6 + F/W M6 x 13mm 4 ② Allen Key M4 1 ③ FH Screw #8 x 32mm 4 ④ L Bracket 4 ⑤ CSK Screw M3.
Assembly Steps Overview Cushion Seat (G) Chair Back (A) Front Leg (B) Side Stretcher (C) Side Rail (F) Side Rail (E) This Dining Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 (1.2) (C) has a small hole for identification. (1.1) (1.
Step 2 (2.2) (2.1) (E) has a small hole for identification. (2.1)Place the Side Rail (E) and Side Rail (F) on the Back Frame to. Side Rail (E) has a small hole for identification. (2.2) Then fix the Side Rail (E) and (F) with Screw ③ using Screwdriver (not provided). DO NOT FULLY TIGHTEN THE BOLT AND SCREWS. Step 3 (3.1) (3.2) Place the Front Leg (B) on the Side Stretcher and Side Rail as shown. Then,(3.
Step 4 Place the Cushion Seat (G) on the table and put the chair on it as shown. Then, fix the Cushion Seat (G) with L-Bracket ④ and Screw ③ using Screwdriver (not provided). DO NOT FULLY TIGHTEN THE BOLT AND SCREWS.
Place the dining chair on a Level Surface to check if it wobbles. loosen the bolts and lift the dining chair some 30cm to 50cm high from the ground, keep your feet and toes well away from the drop zone, and drop the dining chair freely and vertically with the four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment. Test again for evenness on Level Surface. If no wobbles are found, proceed to tighten all the Bolts.
Care & Maintenance Page 7 of 7