User's Manual

ManualsBrandsGeophysical Survey Systems ManualsElectronics5104 Antenna

Table Of Contents

Model 5104 Antenna

System Settings and User Notes

We Provide Complete Survey Solutions

Information People Can Use

Since 1970

Geophysical Survey Systems, Inc.

13 Klein Drive, P.O. Box 97

North Salem, NH 03073-0097

Phone: (603) 893-1109 / FAX: (603) 889-3984

www.geophysical.com

Manual MN30-192 Rev -

sales@geophysical.com

Summary of content (5 pages)

PAGE 1
Model 5104 Antenna System Settings and User Notes We Provide Complete Survey Solutions Information People Can Use Since 1970 Geophysical Survey Systems, Inc. 13 Klein Drive, P.O. Box 97 North Salem, NH 03073-0097 Phone: (603) 893-1109 / FAX: (603) 889-3984 www.geophysical.com sales@geophysical.
PAGE 2
Geophysical Survey Systems, Inc. Model 5104 Antenna System Settings and User Notes Limited Warranty, Limitations Of Liability And Restrictions Geophysical Survey Systems, Inc. hereinafter referred to as GSSI, warrants that, for a period of 12 months from the delivery date to the original purchaser, GSSI's products will be free from defects in materials and workmanship.
PAGE 3
Geophysical Survey Systems, Inc. Model 5104 Antenna System Settings and User Notes FCC Notice (for U.S. Customers): This device complies with part 15 of the FCC Rules: Operation is subject to the following conditions: 1. This device many not cause harmful interference, and 2.
PAGE 4
Geophysical Survey Systems, Inc. Model 5104 Antenna System Settings and User Notes Model 5104 Antenna The Model 5104 antenna has greatly improved resolution performance over previous GSSI mid-frequency antennas, such as the Model 3105 (300 MHz). The Model 5104 can be used in continuous, survey wheel or static stacking modes. The Model 5104 has a center frequency of 275 MHz when measured in air.
PAGE 5
Geophysical Survey Systems, Inc. Model 5104 Antenna System Settings and User Notes Signal Position Place the antenna on the ground and use the Automatic Signal Position selection. The system will servo and place the direct coupling pulse at the top of the time range window. To test that you have the correct position, raise the antenna off the ground and you will observe on your system that the antenna transmit pulse will separate from the reflection from the ground.