and
The installation height of this product is 15 meters and the service area is 3km.
UHF Antenna specification Technical parameters Frequency range (MHz) Bandwidth (MHz) 20 Polarization mode Vertical Gain (dBi) Input impedance 410~470 4 (Ω) Voltage standing wave ratio 50 ≤2.0 Maximum power (W) 20 Joint type TNC Antenna length (mm) 293 Antenna weight (g) 50 Extreme wind speed (km/h) 90 Remark: Antenna structure for elastic whip, and resistance to bending.
UHF Antenna Specification Technical Parameters Technical indicators QT900L Frequency range (MHz) 902.4~928 Bandwidth(MHz) Polarization mode 26 Vertical Gain (dBi) 3 Input impedance (Ω ) 50 Voltage standing wave ratio Maximum power(W) Joint type ≤1.5 20 R-SMA Antenna length(cm) 19.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IC WARNING Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil.
2.2 List of applicable FCC rules This module meets the requirements of Part 15 Subpart C Section 15.247, FCC CFR Title 47 Part 90, FCC CFR Title 47 Part 2. 2.4 Limited module procedures This module is an single module. 2.6 RF exposure considerations Integration is strictly limited to fixed categorized end-products where a separation distance of at least 60 cm between the radiating part and any human body can be assured during normal operating conditions. 2.
IMPORTANT NOTE: Integration is strictly limited to mobile/fixed categorized end-products where a separation distance of at least 60 cm between the radiating part and any human body can be assured during normal operating conditions. IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter).then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product.
IMPORTANT NOTE: Integration is strictly limited to mobile/fixed categorized end-products where a separation distance of at least 60 cm between the radiating part and any human body can be assured during normal operating conditions. IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter).then the IC authorization is no longer considered valid and the IC ID can not be used on the final product.