User's Manual

ManualsBrandsGentex ManualsElectronicsUniversal Garage Door Opener



Programming and Information Guide

Information on compatible products and video programming instructions are available at

www.homelink.com

Only press the transmitter button on the integrated garage door opener if there are no

persons or objects present within the sweep of the garage door. People could otherwise be

injured by the movement of the door.

1

2

3

4

Integrated garage door opener on the rear-view mi

of this integrated garage door opener.

rror Garage door remote control 5 is not part

atteries in garage door remote control 5 before

programming.

e programming, clear all HomeLink memory by following the instructions in the

"clearing memory" section (page 333)

the ignition lock.

ed garage door opener. Indicator lamp

1 lights up yellow.

ntrol 5 towards buttons 2 to 4 on the rear-view mirror at a distance of 2 to 8

inches (5 to 20 cm).

tton 6 on remote control 5 until indicator lamp 1 lights up green. If the

indicator lamp 1 does not turn green, reposition the remote control 5 and repeat this step.

To achieve the best result, insert new b

•► For first tim

•► Turn the SmartKey to position 2 in

•► Press and release one of buttons 2 to 4 on the integrat

•► Point remote co

•► Press and hold bu

HomeLinkandtheHomeLinkhouseareregisteredtrademarksofGentexCorporation.

Summary of content (4 pages)

PAGE 1
Programming and Information Guide Information on compatible products and video programming instructions are available at www.homelink.com Only press the transmitter button on the integrated garage door opener if there are no persons or objects present within the sweep of the garage door. People could otherwise be injured by the movement of the door. 1 2 3 4 Integrated garage door opener on the rear-view mirror Garage door remote control 5 is not part of this integrated garage door opener.
PAGE 2
•► Release button 6 on remote control 5. •► Firmly press, and release the programmed button 2, 3, or 4 of the integrated garage door opener up to three separate times to activate the device. If the device activates, programming is complete. If the device does not activate, continue with "Synchronizing the Rolling Code." Synchronizing the rolling code Your vehicle must be within range of the garage or gate opener drive.
PAGE 3
•► Continue with the other programming steps (see above). Problems when programming If you are experiencing problems programming the integrated garage door opener on the rearview mirror, take note of the following instructions: - Replace the batteries in garage door remote control 5. This increases the likelihood that garage door remote control 5 will transmit a strong and precise signal to the integrated garage door opener in the rear-view mirror.
PAGE 4
•► Press and hold buttons 2 and 4 until the indicator lamp turns green. The following is required text to be included in the Vehicle Owner’s Manual, as part of Homologation regulations globally if applicable. *A general requirement is that the Owner’s Manual shall be written in the native language of the country of use. The device is to be mounted in the vehicle with only the button side of the device exposed to the end user.