User Manual

GARAGE DOOR TRANSCEIVER
WARNINGS
CAUTION: Do not use the transceiver with
any garage door opener that lacks the
safety stop and reverse feature as required by
safety standards.
CAUTION: When programming the
transceiver to a garage door opener or
entry gate, make sure the area is clear. This will
prevent potential harm or damage as the gate
or garage door will activate during the program.
CAUTION
This device may suffer from interference if
operated in the vicinity of a mobile or fixed
station transmitter. This interference is likely to
affect the hand-held transmitter as well as the
in-car transceiver.
The door transceiver is located in the rear-view
mirror. It can be programmed to transmit the
radio frequencies of up to 3 different
transmitters, which can be used to operate
garage doors, entry gates, home lighting,
security systems or other radio frequency
operated devices.
Although this section mainly describes the
procedures for a garage door opener, it equally
applies to the previously mentioned applications.
In some countries, this feature is also known as
the HomeLink® Universal Transceiver. The
transceiver radio frequency approval numbers
for the USA and Canada are shown below:
USA and Puerto Rico - FCC: K8597R315.
Canada - CAN: 2145 101 790A.
Note: HomeLink® is a registered trademark
owned by the Johnson Controls, Inc. Milwaukee,
Wisconsin.
For further information, see See INFORMATION
AND ASSISTANCE (page 7).
United States of America
This device complies with part 15 of the FCC
rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Canada
This device complies with Industry Canada
Standard IC - RSS-210. Operation is subject to
the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Note: Changes or modifications not expressly
approved by the manufacturer could void the
user’s authority to use the equipment.
BEFORE PROGRAMMING
CAUTION
When programming a device that may
require you to press and re-press the
hand-held transmitter (cycle), unplug the device
during the cycling process to prevent possible
motor failure.
For best results, fit a new battery to the
hand-held transmitter of the garage door opener
(or other device) before programming. If your
garage door opener receiver (located in the
garage) is equipped with an antenna, make sure
the antenna is hanging straight down.
5
Garage door opener