User's Manual

ManualsBrandsGenie ManualsElectronicsGARAGE DOOR REMOTE CONTROL RECEIVER

3560935878

For 7' 6" Doors.Extension Kit is available for 8' Doors

Included Wall Console MUST be installed prior to Operation

of this Garage Door Opener.

Safe-T-Beam

Safety Reverse System MUST be Installed and

the Force Controls MUST be Properly set to close door.

This Equipment meets or exceeds all Federal,State and UL325

Safety Requirements.

Will not operate “twice as fast” on one-piece doors.

SAVE THIS MANUAL FOR

FUTURE REFERENCE

Having Difficulty? Need Help?

Please call us: 1-800-784-5028

www.overheaddoor.com

Please have Model information ready when calling.

Warranty Information . . . . . . . . . . . . . . . . . . . 2

Your Documentation Page. . . . . . . . . . . . . . 3

Safety Information. . . . . . . . . . . . . . . . . . . . . . 4

Safety Features. . . . . . . . . . . . . . . . . . . . . . . . . 4

Important Installation Instructions . . . . . . 4

Pre-Installation Checklist. . . . . . . . . . . . . . . . 5

Adjustments . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Programming the Remote Control . . . . . 11

Installation of Light Bulbs. . . . . . . . . . . . . . 12

Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . 13

Troubleshooting Guide. . . . . . . . . . . . . . . . 15

Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . 18

Parts List and Explosions. . . . . . . . . . . . 19,20

Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . 21

TABLE OF CONTENTS

The Genuine. The Original.

DC POWERED SCREWDRIVE OPENER

™

4060

OPERATION AND MAINTENANCE MANUAL

COMPLETE WITH CODEDODGER®

EMOTECONTROL AND SERIESII

LECTRONICS

Summary of content (22 pages)

PAGE 1
3560935878 OPERATION AND MAINTENANCE MANUAL The Genuine. The Original. ™ 4060 DC POWERED SCREWDRIVE OPENER Warranty Information . . . . . . . . . . . . . . . . . . . 2 Your Documentation Page . . . . . . . . . . . . . . 3 Safety Information. . . . . . . . . . . . . . . . . . . . . . 4 Safety Features . . . . . . . . . . . . . . . . . . . . . . . . . 4 Important Installation Instructions . . . . . . 4 Pre-Installation Checklist. . . . . . . . . . . . . . . . 5 Adjustments . . . . . . . . . . . . . . . .
PAGE 2
THE OVERHEAD DOOR CORPORATION LIMITED WARRANTY What is covered? Any defect in material and product workmanship from personal, normal household use in accordance with the Owner’s Manual. For how long? MODEL 4060L — Lifetime* on motor, and parts. * for as long as you own your home. This warranty is non-transferable. Who gets the warranty? This warranty is limited to the consumer who originally purchased the product.
PAGE 3
YOUR OVERHEAD DOOR GARAGE DOOR OPENER DOCUMENTATION PACKAGE The documentation provided with your opener has been carefully designed and organized to make the assembly, operation, and continued maintenance of your product as easy and safe as possible. This material consists of two main items. Operation and Maintenance Manual While it is recommended that all documents be retained for future reference, this manual should contain most of the information that you will need over the lifetime of your product.
PAGE 4
SAFETY INFORMATION OVERVIEW OF POTENTIAL HAZARDS Overhead doors are large, heavy objects that move with the help of springs under high tension and electric motors. Since moving objects, springs under tension, and electric motors can cause injuries, your safety and the safety of others depend on you reading the information in this manual. If you have questions or do not understand the information presented, call The Overhead Door Corp. or your local Overhead Door Distributor.
PAGE 5
PRE-INSTALLATION CHECKLIST WARNING: This Opener includes parts and supplies needed to install in most garages and connect to most garage doors. There are many variations of garages and garage doors. A few additional parts and supplies may be needed to install Opener into your garage and connect to your garage door. While checking items listed below, note any additional items you will need.
PAGE 6
Rail Extension for 8' door Check Step 3: MEASURE GARAGE DOOR HEIGHT Measure garage door height (7'-6", 8'-0", or taller) with tape measure. A If door height is 7'-6" or less, continue with Check Step 4. B If door height is 8'-0", you need a Rail Extension Kit. (Figure 3) (See Accessories Order Form, page 21). C If door height is taller than 8'-0", the door opener you purchased is the wrong version. Contact an Overhead Door Customer Service Representative at 1-800-784-5028.
PAGE 7
Check Step 5: CHECK POWER HEAD MOUNTING AREA Check ceiling or space above where Opener Power Head will be mounted (Figure 5): A Measure from garage door center line mark toward rear of garage: • Approximately 10' back if garage has a 7' 6" door. • Approximately 11' back if garage has an 8' 0" door. NOTE Mounting Straps are included to attach the Opener to most garage ceilings. Garage construction varies widely. Additional mounting straps or angle iron may be needed for your installation.
PAGE 8
Check Step 7: CHECK SAFE-T-BEAM® MOUNTING BRACKET LOCATION Check for wood garage frame, jamb, or masonry at mounting location (6" above floor) with attachment tabs facing away from garage door (Figure 7). A If you cannot mount Safe-T-Beam® Mounting Bracket to wood frame: • Concrete screws and concrete anchors (not included) must be used to mount Brackets on masonry with attachment tabs facing away from garage door.
PAGE 9
ADJUSTMENTS AND MAINTENANCE Adjustment 1: SET LIMIT SWITCHES AND FORCE CONTROLS Coarse Setting of Limit Switches A B Setting Close Limit Switch (Figure 9): • Check that Magnetic Carriage Assembly is disengaged. • With garage door fully closed, slide Close Limit Switch until it is aligned with Carriage Assembly Magnet. • Tighten Set Screw. Do Not over-tighten. Setting Open Limit Switch: • Manually open garage door to full open position.
PAGE 10
NOTE • • D E F To protect your new investment, your opener is equipped with a Timer and Cycle Counter which work together to prevent any chance of heat damage to electrical circuits caused by too many cycles in too short a time. If your Opener suddenly stops responding to the Wall Console - Do Not Unplug the Unit - simply wait 10 minutes for the Timer/Cycle Counter to reset itself and try again. (see page 16, Opener Troubleshooting).
PAGE 11
ACCESSORIES C PROGRAMMING THE Programming 1: REMOTE CONTROLS NOTE • • • • • • A B Each Remote Control must be programmed separately. The Remote Controls will not cause the door Opener to close the garage door if the Safe-TBeam® System is malfunctioning. When programming the Remote Controls, they must be at least 24" from the Antenna Wire. If the red Learn Indicator Light blinks approximately 4 times per second, programming has stopped. If programming has stopped, repeat the above steps.
PAGE 12
ABOUT DUAL FREQUENCY REMOTE TRANSMITTERS Transmitter Compliance Statement Your garage door opener (GDO) features a unique dual frequency remote control system for reliable service in today’s crowded airwaves. Overcrowded airwaves may intermittently interfere with GDO’s remote control system. The dual frequency feature greatly reduces the possibility of unwanted interference. The receiver in the GDO’s powerhead can receive signals at 315 AND 390 MHz. The remote is factory set at 315 MHz.
PAGE 13
SCHEDULED MAINTENANCE A Monthly: • Door springs and door hardware: – Oil door rollers, bearings, and hinges using silicone lubricant or light oil. B Yearly: • Wipe off old excess lubricant from Drive Screw. • Lubricate Drive Screw with Lubricant (GLU-3) NOTE WARNING Do not operate door automatically or manually if springs are broken. Contact an Overhead Door Distributor for service or call Customer Service at 1-800-784-5028. • Balance Door. – Close door.
PAGE 14
NOTES 14 For Help, call 1-800-784-5028 or visit www.overheaddoor.
PAGE 15
IMPORTANT SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF SEVERE INJURY OR DEATH 1 2 3 4 5 6 7 8 READ AND FOLLOW ALL INSTRUCTIONS. Never let children operate or play with the Door Controls. Keep the Remote Control away from children. Always keep the moving door in sight and away from people and objects until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR. Test Opener monthly.
PAGE 16
Opener System Self-Diagnostic Troubleshooting • See Status Light on Figure 10, page 9 or Figure 13,page 11) You See 1 BLINK, Pause (Repeat) Problem Motor Drive Board Interrupt Normal operation restored If the problem recurs Operation not restored 2 BLINKS, Pause (Repeat) Controller Board Interrupt 3 BLINKS, Pause (Repeat) Opener Overheated or Over-cycled Force Settings Incorrect 4 BLINKS, Pause (Repeat) 5 BLINKS, Pause 6 BLINKS, Pause 7 BLINKS, Pause 8 BLINKS, Pause Safe-T-Beam® Malfunction Wall Con
PAGE 17
General Troubleshooting (Always Check the Status LED Light) Problem Opener does not run from Remote Control Door Opener starts for no apparent reason Door starts down, then stops before it is completely closed Door starts down, then stops and goes back up Door will only run closed Door will only run open Lights will not go out Door starts up, but stops before it is completely open Operator runs, but door does not move Wall Console Vacation Lock function does not work What To Do 1.
PAGE 18
General Troubleshooting (Always Check the Status LED Light)(Continued) Problem Remote Control has less than 25’ operating range Opener works from Wall Control, but not from Remote Control Noisy operation • • • • • • • • • • • • Safe-T-Beam® System • • • Door closes, and Opener shuts down • What To Do Relocate Remote Control inside car. Ensure Remote Control is pointing toward garage door when pressing Control Button. Replace Remote Control Battery (See page 11). Reposition Opener Antenna Wire.
PAGE 19
Parts List Item Part Name Item Part Name 1 2 4 4A 4B 4C 6 8 9 10 11 12 13 14 15 16 18 19 21 22 24 25 26 28 30 31 32 33 34 35 36 37* 38* 40* 41* 42* 43* 44* 45* 46 47* 48* 49* 50* 51* 52* 53 55* 56 57 * Power Head Assembly (main carton) 1/4"-20 x 13/16" Hex Head Shoulder Bolt (blue bag) (yellow shoulder bolt) Rail Assembly, 3-Piece First Rail Section (main carton) Middle Rail Section (main carton) End Rail Section (main carton) Carriage Stop 1/4"-20 Hex Serrated Flange Nut (blue bag) Rail Clamps (blue bag)
PAGE 20
EXCELERATOR HARDWARE EXPLODED VIEW NOTE Opener will not function unless Safe-T-Beam® System is installed and Force Controls are properly set. 11 46 46 53 57 6 13 13 14 14 8 8 18 18 21 21 DO OR 53 53 2 2 99 5 4A 19 19 11 11 DO 26 30 10 10 4B 6 OR 32 12 12 88 11 33 33 31 31 16 16 7 4C 30 28 36 36 22 25 56 56 22 23 22 34 34 15 15 32 32 35 35 24 24 33 33 20 For Help, call 1-800-784-5028 or visit www.overheaddoor.
PAGE 21
Garage Door Opener Accessories Order Form Formulario de pedido de accesorios para abridores de puertas de garaje Formulaire de commande des accessoires pour ouvre-porte de garage For additional accessories not shown. visit our website at www.overheaddoor.com Para accesorios adicionalesno mostrada, visite nuestro sitio web en www.overheaddoor.com pour les accessoires supplémentaires pas montré, visiter notré site web à www.overheaddoor.
PAGE 22