User's Manual

ManualsBrandsGenex Telecom ManualsElectronicsTransceiver, VHF, PTT

GX-80/90 Genex Portable LMR radio

FCC RF EXPOSURE COMPLIANCE REQUIREMENTS FOR OCCUPATIONAL USE

ONLY

The Federal Communications Commission (FCC), with its action in General Docket 93-62,

November 7, 1997, has adopted a safety standard for human exposure to Radio Frequency

(RF) electromagnetic energy emitted by FCC regulated equipment. Maxon subscribes to the

same safety standard for the use of its products. Proper operation of this radio will result in user

exposure far below the Occupational Safety and Health Act (OSHA) and Federal

Communications Commission limits.

DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more

than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded.

•This radio is NOT approved for use by the general population in an uncontrolled

environment. This radio is restricted to occupational use, work related operations only

where radio operator must have the knowledge to control the user’s exposure conditions for

satisfying the higher exposure limit allowed for occupational use.

•When transmitting, hold the radio in a vertical position with its microphone 2 inches (5 cm)

away from your mouth.

The radio is transmitting when the red LED on the front of the radio is illuminated.

You can cause the radio to transmit by pressing the PTT bar on the radio.

These are required operating configurations for meeting FCC RF exposure compliance.

Failure to observe these restrictions mean violation.

This equipment complies with the FCC RF Exposure Limits for controlled environments.

- Function description

1. power on& volume control

(1) Power On

Turn radio on by turning the power/volume Rotary switch clockwise out of detent.

When radio turns on, it make beep sound.

(2) Power Off

Turning the power /volume rotary switch counterclockwise out of detent

(3) Volume up/down

Adjusting level of volume by turning Volume rotary switch.

2. Channel Selecting (Up/Down)

User can choose a channel by adjusting Channel rotary switch

Summary of content (6 pages)

PAGE 1
GX-80/90 Genex Portable LMR radio FCC RF EXPOSURE COMPLIANCE REQUIREMENTS FOR OCCUPATIONAL USE ONLY The Federal Communications Commission (FCC), with its action in General Docket 93-62, November 7, 1997, has adopted a safety standard for human exposure to Radio Frequency (RF) electromagnetic energy emitted by FCC regulated equipment. Maxon subscribes to the same safety standard for the use of its products.
PAGE 2
3. RX Operation 1) Busy condition is that unit is receiving a signal fixed in its channel Unit in the busy condition will be operated according to a fixed input of tone and two Tone. Unit out of busy condition will remain LED Off 2) Correct Call If a incoming signal has same tone as a fixed input of tone in selected channel, This signal is called “Correct Unit will open Audio with Green LED, If a incoming signal is not correct call, LED will be On in orange.
PAGE 3
simply press the scan button for a short time while stopped on the channel to be detected. This will remove that channel from the scan list until the channel is changed or the radio’s power is reset. When power is restored or the scan list channel position is again selected, the original dealer programmed scan list will be activated. - Priority Scan On : A single channel is programmed as the “ Priority” channel.
PAGE 4
Allows transmission with pressing PTT. 2) To enable VOX function, first of all VOX function and its level must be set through PC programmer and then turn Radio ` on while pressing PTT. At a moment, radio makes beep sound. 3) TOT (TX Time-out-Timer) This function will be disable TX. When TX inhibit is used in conjunction with the time our timer, Radio will not be able to transmit for the programmed period of time after a time out occurs. 4) TOT Penalty option.
PAGE 5
6. Low Battery Detection 1) RX Low battery If Low battery condition is detected, Radio flash LED with beep sound. In this condition RX/TX is inhibited but one time of TX is allowed. 2) TX low battery If Low battery condition is detected while TX is active, Radio allows TX but it will be inhibited right after end of TX. There is still one-time TX chance in the low battery condition. 7. Scramble Function Four different kind of scramble can be selected to each channel.
PAGE 6