Safety Instructions (FCC) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Safety Instructions Please store this instruction manual for future reference. • WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The apparatus shall not be exposed to dripping or splashing and that objects filled with liquids, such as vases, shall not be placed on apparatus. • WARNING: The direct plug-in adapter is used as disconnect device, the disconnect device shall remain readily operable.
1 2 3 4 1. On / Off / Volume dial Rotate the dial clockwise to switch on GENEVA TIME. Rotate clockwise to increase volume Rotate anti-clockwise to decrease volume and to switch OFF 2. Speaker LED in Bluetooth mode (See “Bluetooth”chapter for more informations): - blinking blue: GENEVA TIME is in pairing mode - fix blue: GENEVA TIME is paired to a device in Line-IN / AUX mode - LED is red NOTE: after 5 minutes non-playing, GENEVA TIME turns automatically off.
1 2 4 3 5 6 1. Battery slot for clock. Use AA 1.5V battery only 2. Rotate the “set clock” dial to adjust time. 3. Line In connector 4. USB charge connector. Max output is 5V - 1A 5. Set alarm dial 6.
Getting started GENEVA TIME is an analogue alarm clock and a Bluetooth speaker. with LineIn/AUX capabilities and wired and wireless charging. IMPORTANT NOTES: 1. The alarm clock has its own ringtone. Bluetooth and Line-IN/AUX inputs cannot be used as alarm clock signal. 2. The alarm clock works with 1 AA battery. Please check the battery annualy. 3. The speaker works only with AC Adapter connected 4. Wireless and wired charging work only with AC Adapter connected 5.
Bluetooth Prior to pairing, verify your device supports Bluetooth 2.1+EDR A2DP and your device is not connected to any other Bluetooth product. Devices may pair differently. Below is a general guide. 1. Turn on Geneva Time. This will power on the Bluetooth. Turn the volume up about ¼ to start. Also turn up the volume on the source device (the device you are streaming from). 2. Turn on the Bluetooth on your device (e.g. smartphone, tablet) 3.
www.genevalab.