User's Manual

Radio Specific Safety Information

Identification

GoBook IX260

transcribed, stored in a retrieval system, or translated into any other language or computer language in

whole or in part, in any form or by any means, whether it be electronic, mechanical, magnetic, optical,

manual, or otherwise, without the prior written consent of Itronix Corporation, 12825 E. Mirabeau

Parkway, Spokane Valley, WA 99216.

Disclaimer

Itronix Corporation reserves the right to revise the manual and make periodic changes to the content

without a direct or inferred obligation to notify any person of such revision or changes. Itronix Corporation

does not assume responsibility for the use of this help manual, nor for any patent infringements or other

rights or third parties who may use the manual.

This document contains valuable trade secrets and proprietary information of Itronix Corporation.

This product is available for purchase under Itronix's standard terms and conditions of sale. Hardware

products may be reconditioned, or be manufactured from parts and components that may be new, used,

rebuilt, or recycled and in some cases, the hardware product may not be new and may have been previously

installed. In any event, Itronix warranty terms apply.

Warnings and Cautions

WARNING It is important that only authorized personnel service and attempt repairs on the equipment.

Unauthorized service or repair may void the warranty and any maintenance contract in effect for the

equipment. Unauthorized service personnel might be subject to shock hazard on some equipment if

removal of protective covers is attempted.

Internal radio(s) may have an individual FCC Identifier which are not applicable to this configuration.

FCC Identifiers: KBCIX260MPIAC860 on the bottom of the IX260 Laptop PC are applicable. The Radios

in the IX260 Laptop PC must not be co-located or operating in conjunction with any other antenna or

transmitter than specified in the above referenced FCC Certification filings .

Safety Information

This device contains a WLAN radio transmitter and a WAN radio transmitter. To comply with FCC RF

exposure requirements when using the WAN radio transmitter, a minimum separation distance of 20 cm

must be maintained between the upper right edge of the display screen antenna and all users/bystanders.

When using the WLAN transmitter, a minimum separation distance of 20 cm must be maintained between

the upper right and left edges of the display screen and all users/bystanders. The WAN transmitter and

WLAN transmitter should be turned off before carrying the Laptop PC in order to comply with FCC RF

exposure requirements

Do not proceed beyond a WARNING or CAUTION until the indicated conditions are fully understood

and met.