Wireless Display System Instruction Manual 1 # f o Pro 09 / 5 1 / 1 0
Table of Contents TABLE OF CONTENTS SAFETY........................................................... Inside Front Cover Read This Manual Thoroughly ........................................... 1 Safety Rules ..................................................................... 1 Operation and Maintenance ............................................... 3 How to Obtain Service ...................................................... 3 INTRODUCTION ...............................................................
Important Safety Instructions hazard areas. Safety should be stressed to all operators, potential operators, and service and repair technicians potential for this equipment. SAVE THESE INSTRUCTIONS – The manufacturer suggests that these rules for safe operation be copied and posted in maintenance of the generator and batteries.
Important Safety Instructions GENERAL HAZARDS • For safety reasons, the manufacturer recommends that this equipment be installed, serviced and repaired by an Authorized Service Dealer or other competent, qualified electrician or installation technician who is familiar with applicable codes, standards and regulations. The operator also must comply with all such codes, standards and regulations.
Wireless Display System FIRE HAZARDS • Keep a fire extinguisher near the generator at all times. Do NOT use any carbon tetra-chloride type extinguisher. Its fumes are toxic, and the liquid can deteriorate wiring insulation. Keep the extinguisher properly charged and be familiar with its use. If there are any questions pertaining to fire extinguishers, consult the local fire department.
Wireless Display System NOTE 2: Figure 2 — Mount Transceiver In battery sleep mode, if the wall transformer is plugged into the unit, it will take up to one minute to recognize this fact. INSTALLATION GENERATOR SIDE TRANSCEIVER INSTALLATION INSTRUCTIONS The following steps will illustrate how to mount the generator side transceiver to the generator. all power sources prior to opening Disconnect the control panel. 1. 2. 3. 4. 5. 6. Set the Auto/Off/Manual switch to the Off position.
Wireless Display System 11. Plug the other end of the wire harness into the 8-way connector at the top of the control panel. The plug will only plug in one way (Figure 5). DO NOT force the plug into the header. Gently insert the plug until it locks into place. Figure 5 — Plug Wire Harness into Header J5 DISPLAY INSTALLATION For easier installation, the batteries should first be fitted into the display unit (Figure 7).
Wireless Display System 4. The display will show that it is searching for the generator and the yellow LED may flash occasionally as it receives data from the generator transceiver. This is due to the unit searching for the correct channel. 5. Once the generator is found, the radio link is now established and the settings will be remembered next time the display unit is turned on.
Wireless Display System BUTTONS ALARM AND STATUS DISPLAY Operation of the display is controlled by three (3) buttons labeled +, —, and Enter. These buttons are used to navigate the display to the required page, or to enter data. The +/— buttons are also referred to as the arrow keys. Holding down a button for more than half a second will cause it to auto repeat until it is released. The display will normally show the operating status of the generator or an alarm message if one is present.
Wireless Display System Figure 14 — Menu System For example: Normal Start* You started the generator at normal speed.
Wireless Display System SETTINGS MENU The following list of options will be presented: • Adjust Contrast • Clear History • Add Me to Network. ADJUST CONTRAST The display contrast can be adjusted using the two arrow keys. Once the desired contrast level is reached, press the enter key to store it. EXERCISE MENU Normally the exercise time is set at the generator control board.
Wireless Display System 3. Figure 17 — Time & Date Menu On the display select “Reset Radio”. The display will show it is searching for the generator, this process will last up to one (1) minute and a countdown timer will be displayed. Once the time is up a message will be displayed showing that the generator has been found. The radio settings will be remembered for the next time. Re-set the exercise time. 4. 5. Monday ADD NEW DISPLAY Time An extra remote display can be added to the network.
Wireless Display System MENU MAP + T Up STATUS Display Status Information GRAPH Graph - Generator Battery Voltage - Generator RPM - Current - Utility Voltage TIME & DATE Set the Clock and Calendar RADIO 1. 2. 3. 4. 5. Down t Time L O G Show Radio Information Change Channels Reset Radio Add New Display Test Radio Link EXERCISE Set an Exercise Time and Day Select Low or High Speed Exercise SETTINGS 1. Adjust Contrast 2. Clear History Log 3.
Exploded Views and Parts Lists Fadd Assembly – Drawing No. 0G8855-B ITEM 1 2 3 4 5 6 7 8 9 10 11 12 12 PART NO. 0G7127 0G7128 0G7161 0G4904 0G6020 0G6019 0G8856 0G8898 0G7130 0G7092 084543A 052777 QTY. 1 1 3 1 1 1 1 1 2 1 2 2 DESCRIPTION CARDBOARD BOX PE-FOAM BATTERY, AAA AC ADAPTOR, 120Vac / 5Vdc HOME SIDE RF ANNUNCIATOR GENERATOR SIDE RF ANNUNCIATOR HARN PCB-RF MOD MANUAL WIRELESS DSP SYS 2008 STATIC SHIELDING BAG 200 X 140 X 0.08t GASKET 2.0 X 4.
Wireless Display System 13
GENERAC POWER SYSTEMS “180 DAY” LIMITED WARRANTY FOR WIRELESS REMOTE MONITOR (FOR AIR-COOLED GENERATORS) For a period of 180 days from the date of original sale, Generac Power Systems, Inc. (Generac) warrants its wireless remote monitor will be free from defects in materials and workmanship for the items and period set forth below.