9301A Operating Manual Genelec 9301A Multichannel AES/EBU Interface
Genelec 9301A Multichannel AES/EBU Interface Introduction Congratulations and thank you for purchasing the Genelec 9301A multichannel AES/EBU interface intended for 7300 series subwoofers. This manual addresses the setting up and use of the Genelec 9301A. The low frequencies in multichannel digital audio AES/EBU signals can be monitored by using the 9301A connected to one or more 7300 series smart active monitoring (SAM) subwoofers, for example products 7360A and 7370A.
Figure 2. Audio and GLM network cabling for an 8.0 channel system. In this configuration the 9301A routes the sum of all eight channel inputs to the subwoofer. POSSIBLE DAISY-CHAINED ADDITIONAL SUBWOOFERS DIGITAL IN GLM ADAPTER DIGITAL OUT DIGITAL IN AES OUT 1 AES IN 1 AES OUT 2 AES IN 2 GLM NETWORK AES OUT 3 AES IN 3 AES OUT 4 SUBWOOFER LINK AES IN 4 (LFE) = AES/EBU DIGITAL CABLING 8.0 CHANNEL AUDIO SOURCE Figure 3. Audio and GLM network cabling for a 7.1 channel system.
9301A automatically wakes up to its normal operation mode. The wait until entering the ISS power save can be configured using the GLM software. When ISS is active you can have your monitoring system ready for action at all times. Installation Connections Two GLM Network connectors are available for computer management using the Genelec Loudspeaker Manager (GLM) software. This software can support analog and digital audio systems with up to 45 monitors and subwoofers.
9301A controls are embedded into the subwoofer controls. Use With GLM™ Management Network The 9301A is fully compatible with Genelec Loudspeaker Manager GLM™ software and the proprietary Genelec monitor management network and Genelec SAM monitors. More information about the use with the GLM™ network is available in the SAM System Operating Manual. System setup The setup is easy and consists of the following steps: • Connect the digital audio to the input connectors.
and compensate your monitors and subwoofers. If you want, you can save the acoustic calibration settings into the monitors, subwoofers, and 9301A units. This enables the use of the calibration data with the GLM network disconnected. Removing the GLM network cable and powering down and up the 9301A and other products on the network enables the use of the stored settings.
Genelec 9301A Multichannel AES/EBU Interface www.genelec.com Genelec Document D0116R003. Copyright Genelec Oy 12.2016. All data subject to change without prior notice International enquiries: In the U.S. please contact: In China please contact: In Sweden please contact Genelec, Olvitie 5 Genelec, Inc.