7300 Series Operating Manual Genelec 7380A Smart Active Subwoofer
Genelec 7380A Smart Active Subwoofer Introduction Thank you for choosing a Genelec product! Fulfilling our customers' dreams by offering people the most truthful sound reproduction possible has been the source of our enthusiasm since 1978. There´s already over one million Genelec monitors around the world - welcome to our story! All Genelec monitors are designed, hand assembled and individually tested at our factory in Iisalmi, Finland.
BYPASS SWITCH CONNECTOR 7380A SMART ACTIVE SUBWOOFER MADE IN FINLAND PHASE WARNING ELECTRIC SHOCK HAZARD. DO NOT OPEN. DO NOT SUBJECT TO WATER OR MOISTURE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. USE EARTHED MAINS CONNECTION ONLY. ROTARY LEVEL ADJUSTMENT DIGITAL LFE LFE CHANNEL LFE +10 dB TEST TONE ISS STORED LAITE ON LIITETTÄVÄ SUOJAKOSKETTIMILLA VARUSTETTUUN PISTORASIAAN. APPARATET MÅ TILKOPLES JORDET STIKKONTAKT. APPARATEN SKALL ANSLUTAS TILL JORDAT UTTAG.
Centralized bass management System setup The centralized bass management method uses fixed 85 Hz crossover filters in the analog output channels in the 7380A SAM subwoofer for the signal feeds going to monitors. All analog signal cables are first routed to the subwoofer's IN connectors and then from the OUT connectors to the respective main monitors. The outgoing signal has the low frequencies removed.
3 4 85 Hz 85 Hz Figure 3. The effect of phase difference between the subwoofer and the main monitors Incorrect phase alignment can cause a drop in the audio level at the crossover frequency. Correct phase alignment eliminates this level dip. See chapter "Setting the Phase Switches." The DIGITAL LFE switch selects the low pass frequency for the LFE signal (see "LFE CHANNEL" below). The possible frequencies are 85 Hz for "OFF" position and 120 Hz for "ON" position.
• If the +10 dB LFE gain is already implemented by another device, for example, a surround sound processor or the output matrix of a mixing console. • When producing an audio format that does not require the use of +10 dB gain on the LFE channel. +100 Level vs Freq (Hz) Bass Roll-Off -4, -8 and -12 dB 7380A 11.5.
the level the monitors. Monitors are usually also calibrated to deliver the same level at the listening position. Use the rotary level adjustment trimmer on the subwoofer and suitable test signals. Normally an octave wide pink noise signal located around 1 kHz is used for monitors and an octave wide pink noise around 40 Hz is used for the subwoofer.
7380A Operating Manual AMPLIFIER SECTION Short term amplifier output power (Long term output power is limited by driver unit protection circuitry) 800 W Amplifier system THD at nominal output <0.01% Mains voltage 100-240 VAC 50/60 Hz Power consumption Standby, ISS active Idle Full output, peak <2 W 40 W 600 W SIGNAL PROCESSING SECTION Signal connectors 7.