LTE IDU Quick installation Guide WLTFGT-145ACN LTE Indoor CPE
Copyright This DOCUMENT is copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of Gemtek Technology Co. Ltd. Notice Gemtek reserves the right to change specifications without prior notice. While the information in this document has been compiled with great care, it may not be deemed an assurance of product characteristics.
1. About this Guide This document provides information and procedures on installation and configuration of LTE Indoor CPE. You could utilize the theoretical information in this guide to setup your device. This Quick Installation Guide covers the basic installation of the LTE Indoor Gateway. 2. What’s in the box? Here's a quick checklist of everything inside your box. Before installing the CPE, verify that you have all the items listed in the package checklist.
3.
LED Indication 1 2 3 4 Icon Status Description ON Power ON OFF Power OFF ON Wi-Fi ON Blinking Transmitting data OFF Wi-Fi OFF ON Wi-Fi ON Blinking Transmitting data OFF Wi-Fi OFF Blinking Searching for Connection ON Connection confirm (will be off after 5 seconds) Power 2.
4. Connectors Connector Description Power The power port is where you connect the power (DC-12V Port) adapter. 2 Power On/Off Switch The on/off switch support to turn on device 3 LAN – RJ -45 The LAN port allows you to connect Modem to your PC or Hub using a Cat.5/6 Ethernet network cable. 4 USB Type A Host Support USB 2.0 Host 5 WPS Holds down the button for 5 seconds to enable WPS function. 6 USIM Slot Support 2FF size ; 1.8V/3.
5. Installation Please follow the steps below to install the device: Step1: Insert SIM card into the device with right direction. Step2: Connect the device LAN port to your PC with a RJ-45 Ethernet cable that is supplied. Step3: Insert the power cord into the LTE Indoor CPE's DC-12V power jack; and insert the plug into power outlet. Step4: Switch ON the power. The device will start the booting process. After a few seconds, the LED lights will start blinking.
6. Easy Setup Please follow the steps below to configure your device through the web interface: Step1: Open the Web browser (Internet Explorer) and enter the default IP address of the IDU CPE : http://192.168.15.1 Step2: Enter username/password to access the web management interface. Username : admin Password : admin Step3: The page displays in your browser after login; you can simply configure the device settings. Signal strength indicator on the upper-left corner of webpage.
7. WiFi Setting Select WiFi from main menu. Then screen will display the default setting of SSID, radio channel, working mode, and SSID broadcast. WiFi Status: WiFi 2.
WiFi 5G Settings: 8
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Professional installation instruction Please be advised that due to the unique function supplied by this product, the device is intended for use with our interactive entertainment software and licensed third-party only. The product will be distributed through controlled distribution channel and installed by trained professional and will not be sold directly to the general public through retail store. 1.
