Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user. 2006/8/16 v1.
European Union Notice: Radio products with the CE marking comply with the R&TTE Directive (1999/5/EC). Compliance with these directives implies presumption of conformity to the following European Norms: •EN 60950-1 Product Safety •EN 300 328 / EN 301 893 Technical requirement for radio equipment •EN 301 489-1/-17 General EMC requirements for radio equipment •EN 50385 2006/8/16 v1.