Wireless 11g Access Point Quick Installation Guide Version 1.
Table of Contents English 1. Before Installation .................................................................................3 2. Install Hardware......................................................................................4 3. Configure your computer’s TCP/IP Settings ..............
1. Before Installation Thank you for purchasing the Wireless 11g Access Point. This guide will help you set-up and configure your Access Point with easy to follow installation instructions. For more detailed or advanced settings, please refer to the User Manual on the CD-ROM.
2. Install Hardware 1. Connect the RJ-45 network cable from your AP’s LAN port to a Hub or Switch or directly to your PC. 2. Attach the included antenna to the connector on the back of the AP. 3. Connect the included Power Adapter to your AP and to a power outlet; your AP should turn on. POWER ANT Intranet Ž Switch • Œ Verify Hardware Installation Verify the following LED lights are on: ACT, Power, Link.
3. Configure your computer’s TCP/IP Settings Windows 2000/XP 1. Click Start; click Settings and then click on the Control Panel. 2. Double-Click the Network Connection icon. 3. Right-Click on the Local Area Connection icon and then click on Properties. The Local Area Connection Properties windows will appear. 4. Under the General Configuration Tab, locate and select TCP/IP with the corresponding network card, then click Properties. The Internet Protocol (TCP/IP) Properties window will appear. 5.
Windows 95/98/98SE/ME 1. Click Start; click Settings and then click on the Control Panel. 2. Double-clicked the Network icon to open the Network Properties window. 3. Under the Configuration tab, locate and select TCP/IP with the corresponding network card, click on the Properties button and the TCP/IP Properties window will appear. 4. Under the IP Address tab, select Specify an IP Address and enter an IP address which same subnet as this AP such as 192.168.1.10 and 255.255.255.
. After the files load, the Windows request you to reboot system. click Yes to reboot your system. 8. Now your computer is ready to access and configure the Access Point. NOTE : The default IP address setting for the AP is a class C IP address (192.168.1.250/ 255.255.255.0). Please make sure that the current workstation is following the class C IP address range, from 192.168.1.1 to 192.168.1.254 .
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
