User's Manual

Torus Qi Wireless Charger
IC ID: 21530-100295 Instruction Manual
FCC ID: 2AGR4-100295
Overview For your safety, please read this manual carefully before using this product.
Devices with built-in wireless charging receiver(iPhone8/8Plus,iPhoneX,
Samsung S6,S7,S8,Note8)
1.Connect the USB-C cable between the wireless charger and power
adapter , plug in the power adapter (shows blue light)
2.Put your device on the charging area, try to locate the device closest to
the center of the charging surface.
3.If you want to charge another device, you can use the USB output.
Applicable Devices
Operation:
1.Stand by: No indicator
2.On charging: Red indicator
3.Fully charged: Blue indicator
Indicator status:
1.Wireless charger
2.User manual
3.USB-C cable
Standard Accessories
1. Input: 5V/2.4A
2. Wireless Charger:5V/1A(5W)
3. Total USB output: 5V/1A
4. Charging distance: <5mm
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules.
Operation is Subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation. Changes or modifications not explicitly
approved by the party responsible for compliance could void the user's
authority to operate this equipment.
Note: this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 and part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and candidate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. During the operation of device a distance of
15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
● Increase the separation between the equipment and any other radio device.
● Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
ISED Statement
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
● This device may not cause interference; and
● This device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
● l’appareil ne doit pas produire de brouillage;
● l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
This equipment complies with Canada radiation exposure limits set forth for
an uncontrolled environment.
During the operation of device a distance of 10 cm surrounding the device
and 10 cm above the top surface of the device must be respected.
Cet équipement est conforme Canada limites d'exposition aux radiations
dans un environnement non contrôlé.
au cours de l'opération de l'appareil sur une distance de 10 cm autour de
l'appareil et de 10 cm au - dessus de la surface supérieure de l'appareil
doit être respecté.
Specification
1.Type-C Input
2.Wireless Charger
3.USB Output
4.Indicator
1.Input 2 Wireless Charger
3. USB Output
4 Indicator
3*3 in