User Manual

ST-04/ST-PACK

QUICKSTART GUIDE

1 Loosen all knobs and completely extend bottom

section (supports should be parallel to ﬂoor).

Tighten the bottom knob.

4 Insert the locking pin into the hole. Once the pin is in place,

move the center pole down slightly until it stops.

2 Make sure all legs are on placed on an even surface. 5 Mount your speaker on the stand using the stand

mount in the bottomof the speaker.

6 Tighten the center pole hand knob.3 Extend the center mounting pole to the desired height.

PAGE 1
ST-04/ST-PACK QUICKSTART GUIDE 1 Loosen all knobs and completely extend bottom section (supports should be parallel to floor). Tighten the bottom knob. 4 Insert the locking pin into the hole. Once the pin is in place, move the center pole down slightly until it stops. 2 Make sure all legs are on placed on an even surface. 5 Mount your speaker on the stand using the stand mount in the bottomof the speaker. 3 Extend the center mounting pole to the desired height. 6 Tighten the center pole hand knob.