User's Manual

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions : (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Regulatory Information
Notice for the USA: FCC Statement
Federal Communications Commission (FCC) Radio Frequency Interference Statement
(USA Only)
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protections against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try one of
more of the following measures:
à Relocate the radio or television antenna.
à Plug the equipment away from the radio or television.
à Plug the equipment into a different electrical outlet, so that the equipment and the radio
or television are on separate electrical circuits.
à Make sure that all your peripheral devices ar also FCC Class B certified.
à Make sure you use only shielded cables to connect peripheral devices to your
equipment.
à Consult your equipment dealer, or an experienced radio / television technician for help.
WARNING: The system verification tests were conducted with GEMPLUS supported
peripheral devices. Cables used with this equipment must be properly shielded to comply
with the requirements of the FCC.
Changes or modifications not expressly approved by GEMPLUS could void the user's
authority to operate the equipment.
"Accessories for use with UL Listed Computers having limited power or Class 2 output"