DESCRIPTION Description Low battery indicator (Green LED) Strobe flasher Red LED OrangeLED Volume control Alarm mode switch Tone control Doorbell tone control Table mounting Speaker FRONT batteries compartment (4 X AA) Wall mounting screw holes Shaker jack Adaptor jack (option) REAR Modular Modular jack PTT line or jack PTT line for a second Amplicall20 connection 2
INSTALLATION Installation (See drawing) INSTALLATION Electrical connection : The apparatus is designed to operate from a 230V 50Hz supply only. (Classified as «hazardous voltage» according to EN60950 standard). The apparatus does not incorporate an integral power on/off switch. To disconnect the power, either switch off supply at the mains power socket or unplug the AC adaptor. When installing the apparatus, ensure that the mains power socket is readily accessible.
INSTALLATION INSTALLATION Setting up Door bell Setting UP Indoor unit 1. The Door Bell can be take with the people who need Wall Mounting the assistance. 2. The door bell can be fixed on the wall or door surround, drill two holes horizontally, 15mm apart, put the supplied anchor into the two holes, hang the door bell on to the two anchors and then instert and tighten screws, and then stick the blank sticker on the two holes. 3.
INSTALLATION Tone Control Switch (3 Positions) Set the tone of the alarm sound. INSTALLATION Note: Do not use a rechargeable battery. Do not put the used battery into the household rubbish, pay attention to battery regulations regarding battery disposal. Door Bell Tone Control The three position switch allows you to set a different tone when the door bell rings. Change the Battery of Indoor unit The unit requires 4×AA batteries 1. Open the battery door. 2. Insert four AA batteries into the compartment.
INSTALLATION (the other 2 LED light), then press and hold the Pairing/Test button until the 1st LED goes off, beeps to confirm. The 1st remote is now un-registered. 3. If user wants to keep the 1st remote but un-register the 2nd or3rd remote, when the 1st LED flashes, press the Pairing/Test button again, the 2nd LED flashes (other 2 LED light) to select which remote to be un-registered. To check whether the unit works normally, you can press the pairing/Test button, the unit would sound alarm and flash.
INSTALLATION When it is connected to the power adaptor or it has been installed 4 batteries, bell rings normally, or camera LED blinks normally, when there is an incoming call, the shaker doesn’t vibrate. If the AmpliCALL20 does not ring when the doorbell is pressed 1) Check if it is connected to the shaker correctly. 2) Check if the shaker socket has been damaged. 3) Check if the alarm mode selection switch position is correct. 1) Check that the red light on the doorbell flashes when it is pressed.
REGULATORY COMPLIANCE company will notify the customer as soon as possible. Also, you will be advised of your rights to file a complaint with the FCC if you believe it is necessary. - The telephone company may make changes in its facilities, equipment, operation or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.
GARANTIE Opening the equipment or any attempt to perform repairs will void the warranty. For service or repairs, call 1-888-864-2446. From the moment your Geemarc product is purchased, Geemarc guarantee it for the period of one year. During this time, all repairs or replacements (at our option) are free of charge. Should you experience a problem then contact our helpline or visit our website at www.geemarc.com. The guarantee does not cover accidents, negligence or breakages to any parts.