mr Installation, Operating & Maintenance Instructions .
mr Installation, Operating & Maintenance Instructions .steam ________________________________________________________________________________________________ mr Installation, Operating & Maintenance Instructions .
mr Installation Instructions .steam ________________________________________________________________________________________________ Before Installing Carefully inspect the control and packaging for shipping damage. In the event of shipping damage, please contact the carrier for claim information. Our customer service department can assist you with any missing or damaged parts.
mr Installation Instructions .steam ________________________________________________________________________________________________ mr Installation Instructions .steam ________________________________________________________________________________________________ Installation Instructions for AirTempo Flush Mount AirTempo Step 1 Determine the desired installation location of the control.
mr Installation Instructions .steam ________________________________________________________________________________________________ Installing the Remote Temperature Probe (PN: MSTS) The Remote Temperature Probe is required when the AirTempo control is installed outside the steam room. ! CAUTION The Remote Temperature Probe is for use with AirTempo, iTempo and iTempoPlus controls only. Do not use with any other controls.
mr Installation Instructions .steam ________________________________________________________________________________________________ 5. Route the end of the probe cable with the temperature probe through the wall into the steam room as shown in Diagram 2. important note: Do not strain, staple, pinch or otherwise damage the probe cable. 6. With a minimal length of the cable exposed apply silicone (provided) to the hole in the wall as required to create a moisture seal as shown in Diagram 2. 7.
mr Operating Instructions .steam ________________________________________________________________________________________________ Setting the Temperature mr Operating Instructions .steam ________________________________________________________________________________________________ Diagram 3 Diagram 3: Press TEMP key to set the desired temperature or display the temperature setting. The control is preset and will display a temperature setting of 110˚F (default setting).
mr Maintenance Instructions .steam ________________________________________________________________________________________________ mr Maintenance Instructions .steam ________________________________________________________________________________________________ Battery Replacement System Status Codes The batteries in AirTempo will need periodic replacement. Both batteries should be replaced at the same time with new CR2450 coin cell batteries.
mr Maintenance Instructions .steam ________________________________________________________________________________________________ mr Maintenance Instructions .steam ________________________________________________________________________________________________ FCC/Industry Canada Two Part Statement: Parts List: This device complies with FCC Part 15 and Industry Canada license exempt RSS standard(s).
18 19
www.mrsteam.com Products, information and specifications are subject to change without notice. For more information call Sales & Support at: 1.800.76.STEAM (East Coast) 1.800.72.STEAM (West Coast) mr.steam Sussman-Automatic Corporation hello@mrsteam.com www.mrsteam.com 9410 S. La Cienega Blvd., Inglewood CA 90301 800 72 8326 fax: 310 216 2944 ® 43-20 34th Street, Long island City NY 11101 800 767 8326 fax: 718 472 3256 PN 100503 rev 1.
